- Out-of-Stock

The special construction of the braid facilitates installation in all conditions. Lanberg’s braid is built in such a way, so that one edge overlaps the other, forming a tube. The tuck (overlap) is about 25% of the tube's diameter. Braid is applied by stretching the edges and inserting cables inside. This cable accessory perfectly insulates and suppresses vibrations which is a very important factor in the case of applications for electronic equipment. Resistant to gasoline, chemicals (oil, lubricants), cleaning agents, UV radiation.
No product available!
No product available!
No product available!
Braided tape designed to remove excess molten solder. 1.9 mm wide, 15 m long. CHEMTRONICS HQ-WICK-L5
No product available!
No product available!
No product available!
AVT kit for self-assembly of a unipolar stepper motor driver. AVT1985 B
No product available!
Phone ringing indicator with a relay - a set for self-assembly
No product available!
No product available!
Male terminal block, angled, 8-pin. Pitch 3.5mm. Height 9.2mm. KF2EDGR
No product available!
No product available!
No product available!
NanoPi NEO is a miniature board with the all-in-one SoC Allwinner H3 chip (ARM Cortex-A7) with built-in Ethernet communication. Works with Ubuntu MATE, Debian, etc. It can be powered by the microUSB port. The board also contains a USB port, a serial port and a 36-pin GPIO connector.
No product available!
KT30 multimeter from Kemot with 3 1/2 digits display. The multimeter enables measurement of: DC and AC voltage up to 500 V, current up to 10 A, resistance up to 20 MΩ. Diode, transistor and circuit continuity tester
No product available!
No product available!
No product available!
The special construction of the braid facilitates installation in all conditions. z28421