- Out-of-Stock

1.75 mm PLA filament for 3D printing by ROSA3D. 0.8 kg of filament is wound on the spool. The recommended printing temperature is in the range from 185°C to 225°C, and the bed temperature during printing in the range from 40°C to 60°C, however, when using adhesives, heating the bed is not necessary.
Rosa3D is a Polish manufacturer of filaments intended for both hobby and industrial printing. Thanks to many years of experience and modern machinery, the company is able to provide good quality and accuracy of the diameter and roundness of the filament.
Data sheet
Knife designed for trimming and processing of prints from a 3D printer. It consists of a plastic handle and a replaceable, curved blade made of steel
Adhesive increasing the adhesion of 3D prints to the glass table. It makes it easier to work with all materials and prevents undesirable curling of the elements. Dimafix Spray 400ml
Adhesive increasing the adhesion of 3D prints to the glass table. It makes it easier to work with all materials and prevents undesirable curling of the elements. Dimafix Pen 90ml
15-channel infrared transmitter - set for self-assembly
No product available!
AVT kit for self-assembly of the regulator for the rectifier. AVT3166 B
No product available!
Expansion card dedicated for sets from the Terasic DE FPGA series. It contains mainly elements necessary for communication (Wi-Fi module and Bluetooth) and sensors (light, humidity, temperature, accelerometer, gyroscope and magnetometer). The built-in UART <> USB converter enables communication with a PC. Terasic P0499
No product available!
AVT kit for self-assembly of a practical power splitter with quick-release clamps. AVT3175 B
No product available!
The module with the GPS AT6558 chip, designed for the M5Stack sets. The system can receive data from the main positioning systems: GPS, GLONASS, BDS, Galileo, QZSS and SBAS. M5Stack U032
No product available!
No product available!
No product available!
No product available!
No product available!
MYIR MYS-7Z0007S-C is a single board module based on the Xilinx XC7Z007S-1CLG400C chip (Zynq-7007S). This system consists of a single-core processor based on Cortex-A9 core, which can operate at a maximum frequency of 667 MHz and Artix-7 FPGA. The computer is equipped with 512 MB of DDR3 SDRAM, 4 GB of eMMC memory and 16 MB of QSPI Flash memory
No product available!
No product available!
No product available!
Printed circuit board and programmed circuit for event counter. AVT3188 A +
No product available!
Machine Screw: #4-40, 1/2" Length, Phillips (25-pack)
No product available!
No product available!
ROSA3D filament made of high-quality PLA granules. 1 kg of 1.75 mm filament is wound on the spool. ROSA3D PLA Plus ProSpeed White
No product available!
ROSA3D filament made of high-quality PLA granules. 0.8 kg of filament with a diameter of 1.75 mm is wound on the spool. ROSA3D PLA Rainbow Silk Ocean