- Out-of-Stock

1.75 mm PLA filament for 3D printing by ROSA3D. 0.8 kg of filament is wound on the spool. The recommended printing temperature is in the range from 185°C to 225°C, and the bed temperature during printing in the range of 40°C - 60°C, however, when using adhesives, heating the bed is not necessary.
Rosa3D is a Polish manufacturer of filaments intended for both hobby and industrial printing. Thanks to many years of experience and modern machinery, the company is able to provide good quality and accuracy of the diameter and roundness of the filament. Filament PLA Starter from Rosa3D was designed for beginner users of 3D printers. The simplicity of PLA Starter printing will allow you to enjoy aesthetic prints, and over time will convince you to print more and more complex and demanding projects.
PLA is the basic material used in 3D printing. PLA Starter is characterized by low shrinkage and no unpleasant odor. The prints are characterized by excellent layer adhesion and very good detail reproduction. The filament is made of a biodegradable biopolymer. It was made of ingredients approved for contact with food.
3D printer with dual color print and heated table. The printer is fully assembled and ready to use. Flashforge Creator PRO
Knife designed for trimming and processing of prints from a 3D printer. It consists of a plastic handle and a replaceable, curved blade made of steel
Adhesive increasing the adhesion of 3D prints to the glass table. It makes it easier to work with all materials and prevents undesirable curling of the elements. Dimafix Spray 400ml
Adhesive increasing the adhesion of 3D prints to the glass table. It makes it easier to work with all materials and prevents undesirable curling of the elements. Dimafix Pen 90ml
3D printer with two extruder and a heated table. It is fully assembled and ready to use. Flashforge Creator Pro 2
MicroHDMI-HDMI cable in black and 1 meter length. It has a gold plated plug.
No product available!
No product available!
Assembled programmed event counter, equipped with the ability to remember the result, audible signaling
pass the impulse and the executive system with the relay. AVT1824 C
No product available!
No product available!
No product available!
No product available!
The evaluation kit is equipped with the Lattice iCE40 HX FPGA chip. The kit is supported by iCEcube2 and Verilog and Lucid languages. SparkFun DEV-16526
No product available!
No product available!
Battery: Li-Po; 3.7V; 2000mAh; Outputs: wires with 2-pin JST-PH connector; 5.8 mm x 54 x 60 mm. PRT-08483
No product available!
ShutterBoxDC allows you to control roller blinds, awnings, venetian or windows equipped with low voltage (12-24V) DC motor by using a smartphone or tablet, also from anywhere in the World.
No product available!
No product available!
No product available!
No product available!
Tape, in the form of a braid, to remove the excess of molten solder brazing material during soldering and desoldering of electronic components 1.5m
No product available!
The Arduino GSM Shield connects your Arduino to the internet using the GPRS wireless network. Just plug this module onto your Arduino board, plug in a SIM card from an operator offering GPRS coverage and follow a few simple instructions. You can also make/receive voice calls (you will need an external speaker and microphone circuit) and send/receive SMS messages.
No product available!
No product available!
ROSA3D filament made of high-quality PLA granules. 0.8 kg of filament with a diameter of 1.75 mm is wound on the spool. ROSA3D PLA Starter Steel