- Out-of-Stock
Measurements of resistivity and permittivity of solid dielectrics
ID: 63318
Michał Lisowski
This monograph covers a wide range of problems related to volume and surface resistivity measurements as well as electrical permeability and dielectric loss ratio of solid dielectrics.
It contains a thorough analysis of the impact of various factors on the accuracy of measurements and a description of how to minimize them and estimate the uncertainty of measurement results.
Its content is based on modern knowledge in the field of electrical material science and electrical metrology and on many years of experience of the author acquired in an accredited research laboratory of dielectric materials.
Table of Contents
1. Introduction
2. A dielectric in a permanent electric field
3. A dielectric in an alternating electric field
4. Samples of materials and electrodes tested
5. Measurements of through resistivity
6. Surface resistivity measurements
7. Methods and measuring systems of high resistances
8. Measurements of electric permittivity and dielectric loss factor
9. Methods and systems for measuring electrical permeability and dielectric loss factor
10. Uncertainty of measurement results
11. Summary
Literature.
63318
Other products in the same category (16)
BPI AD/DA extend module with the PCF8591 single-chip, single-supply low-power 8-bit CMOS data acquisition device with four analog inputs, one analog output and a serial I2C-bus interface
Retired
No product available!
No product available!
5dB antenna for the Banana Pi R1 router in the version with 300Mps wifi and five LAN 100/1000 ports.
Retired
No product available!
STM32F103 programming cable for Open Debugger Burn Board and Banana Pi G1 connection
Retired
No product available!
CC3200 programming cable for Open Debugger Burn Board and Banana Pi G1 connection
Retired
No product available!
CC2530 and CC2540 programming cable for Open Debugger Burn Board and Banana Pi G1 connection
Retired
No product available!
It is a standard audio-video cable, which can be successfully used to connect Banana Pi M1 or Raspberry Pi 1 model B and A. Cable length is 98 cm, has two ends of the chinch type.
Retired
No product available!
COM-11964 Button a white economy grade 100mm diameter (outside diameter) dome illuminated push button comes with an LED, securing nut and a long life horizontal microswitch.
Retired
No product available!
Cobbler Plus - adapter enabling connection of GPIO Raspberry Pi A +, B + and Pi 2 lines to the contact plate (2.54 mm). The version is assembled. Adafruit 2029
Retired
No product available!
T-Cobbler Plus - adapter enabling connection of GPIO Raspberry Pi A +, B + and Pi 2 lines to the contact plate (2.54 mm). Goldpin connectors are included, for self-assembly. Adafruit 1989
Retired
No product available!
FPC tape length 250 mm, 50 lines, pitch 0.5 mm. Adafruit 1682
Retired
No product available!
μHex is the first low-power controller which is compatible with Arduino. It is very suitable for the battery power supply environment. A 210mAh CR2032 cell battery could make it work 60 days long. DFR0343
Retired
No product available!
The Leonardo ETH is a microcontroller board based on the ATmega32U4 and the new W5500 TCP/IP Embedded Ethernet Controller (datasheet).
Delivery date unknown
No product available!
The DE0-Nano-SoC Development Kit presents a robust hardware design platform built around the Altera System-on-Chip (SoC) FPGA, which combines the latest dual-core Cortex-A9 embedded cores with industry-leading programmable logic for ultimate design flexibility
Retired
No product available!
Ribbon Cable, IDC Socket, IDC Socket, 40 Ways, 5.91 ", 150 mm, 2.54 mm
Retired
No product available!
No product available!
Michał Lisowski