- Out-of-Stock
Shelly Plus 2PM - switch with 2 relays with WiFi and Bluetooth
ID: 1181157
Switch with 2 relays for box mounting. It offers the ability to control two devices with an operating current up to 10 A each (up to 16 A in total) and a voltage from 110 to 240V AC or from 24 to 30V DC. Shelly Plus 2PM
Description
Switch module based on 2 relays with control function via WiFi or Bluetooth. It can be powered by a wide range of voltages (from 110 to 240 V AC or from 24 to 30 V DC) and can control devices with a current consumption of up to 10 A each (16 A in total), so that the user can automate work, measure energy consumption and analyze data . It allows you to set up different types of activities, scenarios and schedules to keep the action in sync with your daily activities. The module is protected against overload and overheating.
Shelly Plus uses the ESP32 module. It allows the simultaneous use of communication with the cloud and MQTT and supports up to 10 connections in parallel. The control is carried out using the transparent Shelly Cloud application available for Android and iOS platforms. The device is compatible with Amazon Alexa and Google Home. It can be used with a local or centralized server and allows you to completely isolate the Internet from the public network.
Features
- Channels: 2
- ESP32 chip with 4 MB RAM
- Intelligent on/off
- Local and remote control
- Weekly schedule function
- Maximum RF output power: 13.34 dBm
- Protocol: Wi-Fi 802.11 b/g/n
- Radio frequency: 2412 - 2483 MHz
- Wi-Fi range: up to 50 m
- Bluetooth
- Overheating protection
- Overload protection
- Power measurement
- Working temperature: -20°C to +40°C
- Device power consumption: up to 1.4 W
- Power supply AC 110-240V, 50/60Hz, DC 24 to 30V
- Maximum load: 10 A per channel (16 A total)
- Dimensions: 42 x 38 x 17 mm
1181157
Other products in the same category (16)
Soldering station 5in1: hotair 100..480 degrees C, soldering tip 75W, power supply 0..15V / 1A, RF signal tester, voltage meter. Included, among others set of nozzles and wires for the power supply
Retired
No product available!
No product available!
No product available!
Laboratory power supply KORAD KA3005P 0-30V 5A communication with PC memory 5 power profiles
Retired
No product available!
This compact, inexpensive plastic gearmotor (high-power brushed DC motor with a 120:1 reduction gearbox) is well suited for use in small robots. While intended for operation at 4.5 V, it should run comfortably in the 3 V to 6 V range.
Retired
No product available!
Digital Proximity, Ambient Light, RGB and Gesture Sensor, Avago Technologies, RoHS
Retired
No product available!
Integrated analogue base station RFID (front-end) of the company EM Microelectronic with a frequency of 13.56MHz. The system has a SOP20 housing
Retired
No product available!
Computer fan housing Raspberry Pi 3, Raspberry Pi 2 model B and Raspberry Pi 1 model B + in dark blue plastic color
Retired
No product available!
Case for the Raspberry PI 2 model B, Raspberry PI 1 model B+ and Raspberry PI 3 computers, manufactured from high quality acrylic. CLEAR
Retired
No product available!
No product available!
No product available!
No product available!
Infrared sensor that allows measurement of distances up to 15cm, has a built-in infrared illuminator, IR receiver and a perimeter of the received signal
Retired
No product available!
Miniature (22x13.5x6mm) WiFi module b / g / n with TCP and UDP protocols operating in standalone and access point modes. 2.0mm goldpin connector. The module is equipped with a UART interface, it is also possible to control GPIO lines (also as PWM). Powered by 3.3V. Antenna: copper wire
Retired
No product available!
Ultra miniature WiFi b/g/n module, equipped with UART, SPI, PWM and GPIO interfaces. The ability to work as an access point and in standalone mode. 3.3V power supply.HF-LPT200-1
Retired
No product available!
This transducer is about 45mm in diameter and has 4Ω impedance and should be run at about 5W
Retired
No product available!
Switch with 2 relays for box mounting. It offers the ability to control two devices with an operating current up to 10 A each (up to 16 A in total) and a voltage from 110 to 240V AC or from 24 to 30V DC. Shelly Plus 2PM