STM32F100ZCT6

STM32F100ZCT6
ARM Cortex-M3 CPU, 256kB Flash, 24kB RAM, 2xUART, 3xUSART, 2xI2C, 3xSPI, CEC, ADC, DAC, STM, LQFP144, RoHS

The STM32F100ZC incorporates the high-performance ARM Cortex™-M3 32-bit RISC core operating at a 24 MHz frequency, high-speed embedded memories Flash memory 256 Kbytes and SRAM - 24 Kbytes, a flexible static memory control (FSMC) interface and an extensive range of enhanced peripherals and I/Os connected to two APB buses. All devices offer standard communication interfaces (two I2Cs, three SPIs, one HDMI CEC, three USARTs and 2 UARTS), one 12-bit ADC, two 12-bit DACs, 10 general-purpose 16-bit timers and an advanced-control PWM timer.

Features:

• Core: ARM 32-bit Cortex™-M3 CPU
  • 24 MHz maximum frequency, 1.25 DMIPS /MHz (Dhrystone 2.1) performance
  • Single-cycle multiplication and hardware division
• Memories
  • 256 to 512 Kbytes of Flash memory
  • 24 to 32 Kbytes of SRAM
  • Flexible static memory controller with 4 Chip Selects. Supports SRAM, PSRAM and NOR memories
  • LCD parallel interface, 8080/6800 modes
• Clock, reset and supply management
  • 2.0 to 3.6 V application supply and I/Os
  • POR, PDR and programmable voltage detector (PVD)
  • 4-to-24 MHz crystal oscillator
  • Internal 8 MHz factory-trimmed RC
  • Internal 40 kHz RC
  • PLL for CPU clock
  • 32 kHz oscillator for RTC with calibration
• Low power
  • Sleep, Stop and Standby modes
  • V_BATsupply for RTC and backup registers
• Serial wire debug (SWD) and JTAG I/F
• DMA
  • 12-channel DMA controller
  • Peripherals supported: timers, ADC, SPIs, I²Cs, USARTs and DACs
• 1 × 12-bit, 1.2 μs A/D converter (up to 16 ch.)
  • Conversion range: 0 to 3.6 V
  • Temperature sensor
• 2 × 12-bit D/A converters
• Up to 112 fast I/O ports
  • 51/80/112 I/Os, all mappable on 16 external interrupt vectors and almost all 5 V-tolerant
• Up to 16 timers
  • Up to seven 16-bit timers, each with up to 4 IC/OC/PWM or pulse counter
  • One 16-bit, 6-channel advanced-control timer: up to 6 channels for PWM output, dead time generation and emergency stop
  • One 16-bit timer, with 2 IC/OC, 1 OCN/PWM, dead-time generation and emergency stop
  • Two 16-bit timers, each with IC/OC/OCN/PWM, dead-time generation and emergency stop
  • Two watchdog timers
  • SysTick timer: 24-bit downcounter
  • Two 16-bit basic timers to drive the DAC
• Up to 11 communications interfaces
  • Up to two I²C interfaces (SMBus/PMBus)
  • Up to 3 USARTs (ISO 7816 interface, LIN, IrDA capability, modem control)
  • Up to 2 UARTs
  • Up to 3 SPIs (12 Mbit/s)
  • Consumer electronics control (CEC) I/F
• CRC calculation unit, 96-bit unique ID