Category: RETIRED PRODUCTS

Orange Pi NAS expansion card makes it possible to transform an Orange Pi Zero into a file sharing server by plugging in an external SATA hard drive

Programmable BT4.0 module with UART 2x4 pin 2.54 mm UART connector

Assembled solar collector differential controller. AVT5621 C

EP11 / 16

Battery: Li-Ion; 3.7V; 400mAh; Outputs: wires with 2-pin JST-PH connector; 50.8 mm x 33.5 x 5.9 mm. PRT-13851

The GY-GPS6MV1 module is a board containing the U-blox NEO-6M GPS receiver system. The tile also includes RTC backup battery, antenna connector (U.FL), voltage stabilizer and UART signal outputs

3DR Radio is a set that allows bidirectional transmission of telemetry data, eg between the RC model (with the APM controller) and a PC. Light and small device in a set with antennas and connecting cables. Radio modules have a power of 100mW (+ 20dBm) and transmit a signal over a distance of 1km.

A small USB splitter allowing to connect up to 4 USB devices, powered from the USB port

The Teensy is a breadboard-friendly development board with loads of features in a, well, teensy package. Each Teensy 3.2 comes pre-flashed with a bootloader so you can program it using the on-board USB connection: No external programmer needed! PJRC TEENSY32

PJRC TEENSYLC

This is the Teensy Audio board add-on for the Teensy 3.x line development boards. This audio board provides you with an easy-to-use tool to add high quality 16 bit, 44.1 kHz sample rate audio to your Teensy project. PJRC TEENSY3-AUDIO

EDW11 / 16

Raspberry Pi 3 & MathWorks Learn to Program Pack is a set consisting of a Raspberry Pi 3 computer with necessary hardware and MATLAB & Simulink Student Suite software. The set is designed for modeling and implementing solutions based on Raspberry Pi 3 in MATLAB and SIMULINK environments

PCB for USB-1-Wire converter. AVT1787 A

AVT kit for self-assembly of the USB-1-Wire converter. AVT1787 B

Assembled USB-1-Wire converter. AVT1787 C

PCB for MKP - control and measurement module with USB interface. AVT5425 A

AVT kit for self-assembly MKP - measuring and control module with USB interface. AVT5425 B

Assembled MKP kit - control and measurement module with USB interface. AVT5425 C

Printed circuit board for mounting running lights. AVT795 A