Category: RETIRED PRODUCTS

A pre-installed radio for everyone. AVT5540 C

PCB board and programmed circuit for a simple digital thermostat. AVT1878 A +

Assembled simple digital thermostat. AVT1878 C

PCB board and programmed circuit for the start-stop time relay. AVT1879 A +

Assembled start-stop time relay. Ideally suited as a controller for lighting, heating or ventilation ventilation. AVT1879 C

AVT kit for self-assembly of the ON / OFF timer. AVT1821 B

Assembled ON / OFF timer. AVT1821 C

AVT kit for self-assembly of a digital thermostat. AVT5441 B

GoodBrand CUBE Blue Pendrive with 8 GB capacity equipped with USB 2.0 interface. Maximum read speed: 22 MB / s, maximum write speed: 10 MB / s

This gearmotor is a powerful 12V brushed DC motor with a 18.75:1 metal gearbox and an integrated quadrature encoder that provides a resolution of 64 counts per revolution of the motor shaft, which corresponds to 1200 counts per revolution of the gearbox’s output shaft. These units have a 16 mm-long, 6 mm-diameter D-shaped output shaft. This gearmotor is also available without an encoder.

Power module with IRFR4105Z transistor (MOD-30.Z), maximum current 2A, 5V power supply or 5V - 12V range (selection by jumper)

CC2530 and CC2540 programming cable for Open Debugger Burn Board and Banana Pi G1 connection

The housing for the Banner PI G1 Debugger made of transparent plastic. Housing for self-assembly

The I2C electric level conversion module is specifically designed for Banana Pi. The module converts the 3.3V of I2C electric level to 5V level or converts 5V to 3.3V

BPI AD/DA extend module with the PCF8591 single-chip, single-supply low-power 8-bit CMOS data acquisition device with four analog inputs, one analog output and a serial I2C-bus interface

Antena 3 DB do Banana Pi R1

5dB antenna for the Banana Pi R1 router in the version with 300Mps wifi and five LAN 100/1000 ports.

STM32F103 programming cable for Open Debugger Burn Board and Banana Pi G1 connection

CC3200 programming cable for Open Debugger Burn Board and Banana Pi G1 connection

It is a standard audio-video cable, which can be successfully used to connect Banana Pi M1 or Raspberry Pi 1 model B and A. Cable length is 98 cm, has two ends of the chinch type.