Category: STARTER KITS, PROGRAMMERS, MODULES

MicroMod main module with nRF52840 chip equipped with Bluetooth 5.1. The board uses an M.2 connector, so it can work with MicroMod expansion boards. SprakFun DEV-16984

Adapter with Grove connector to DMX512 connector (EIA-485 standard). The module is based on the SN75176 converter system. Seeed Studio 103020000

Development kit with the nRF5340 Bluetooth 5.2 SoC chip, which supports BLE, BT mesh, NFC, Thread and Zigbee protocols. Nordic Semiconductor nRF5340-DK

The expansion module is designed to work with Raspberry Pi 400 - a  portable computer built into the keyboard. The board has a 40-pin connector in the pin position and two Qwiic connectors. SparkFun DEV-17512

Module with MQ5 LPG concentration sensor. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020056

Module with green LED diode and potentiometer. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104030007

Module with SHT31 temperature and humidity sensor. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020212

NUCLEO series starter kit equipped with a STM32WL55JC microcontroller (256 KB Flash, Cortex-M4/M0+), with a built-in STLINK-V3E programmer-debugger, equipped with Arduino-compatible connectors

Module with white LED diode and potentiometer. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104030009

Module with blue LED diode and potentiometer. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104030010

A set with a radio transmitter and receiver operating at 433 MHz. The modules are equipped with Grove connectors and communicate via a digital interface. Seeed Studio 104020002

A set with a radio transmitter and receiver operating at 315 MHz. The modules are equipped with Grove connectors and communicate via a digital interface. Seeed Studio 113020001

Expansion board for WRTnode computer with 4 USB ports and 100Mb Ethernet interface. Shield has connectors with SPI, UART, I2C interfaces. DFRobot DFR0352

K-Type Thermocouple Module

Beetle BLE is another milestone in wearable electronics device area based Arduino Uno, which makes DIY users have more options in the project design. It is fully compatible with Bluno in instructions and procedures, supporting Bluetooth HID and ibeacon modes. And it not only supports USB programming, but also wireless programming method. DFR0339

The power module is designed to work with BBC micro:bit boards. It is equipped with a buzzer and a CR2032 battery socket. Kitronik 5610-V2

Module with a button and red LED backlight. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 111020044

Module with 2 relays SSR G3MC202P with a load up to 2 A. The board is equipped with a Grove connector and is controlled via digital inputs. Seeed Studio 103020134

Waterproof strip with RGB LED diodes, 1 m long (60 LEDs per meter). The LEDs are mounted on a flexible white PCB, the tape has a Grove connector. Seeed Studio 104020109

Development board with ESP32 module (WiFi + Bluetooth). Equipped with a 40-pin connector compatible with Raspberry Pi HAT. Waveshare ESP32 One