Shielded FTP category 6 Ethernet network cable with RJ45 plugs. Lanberg PCF6-10CC-0300-S

CAN module based on the SN65HVD230 system, allows you to connect a microcontroller with a CAN bus interface

The MX-5569-12 socket is a 12-pin, right-angle compactible with Mini-Fit Jr. connector with a 4.2 mm pitch, designed for wire-to-board mounting. Engineered for reliable power and signal transmission, it is commonly used in industrial equipment, computer systems, and power supply applications.

Unshielded UTP category 6 Ethernet network cable with RJ45 plugs. Lanberg PCU6-10CC-0025-S

Female terminal block, 4-pin. Pitch 5.0mm. Height 15mm. 2EDGK-5.0-4P. Set of 5 pieces

Brass connector for hoses with a diameter of 6 mm, in a straight version, enables a durable and tight connection of flexible hoses. Intended for use with water, oil and gas in technical and workshop installations.

A single high-throughput operational amplifier in the SOT23-5 housing. STMicroelectronics TSX921IYLT

The Step-Down converter module converts the input voltage of 14 - 26 V to a constant 12 V, with a maximum output current of 3 A, recommended up to 0.8 A for long-term operation. The conversion efficiency of the device is 96% and the module size is 22.3 x 17 x 4.2 mm

Module with 16-channel I/O ports expander controlled by the I2C interface. It was based on the MCP23017 chip

The Sunon MF60152V2-1000U-A99 fan provides stable cooling of electronics and industrial devices thanks to an efficient brushless motor and a design resistant to high temperature. It works well in systems requiring reliable operation with a limited noise level.

Step-Down converter module with an input voltage of up to 5.5 V, an output voltage of 3.3 V and an output current of 1.2 A (2 A instantaneous current). Adafruit 4711

Rod antenna 2.4G, gain 5dBi, connector type: IPEX/U.FL, RoHS

The DG35C-B-02P-13-200AH terminal block is a high-quality PCB mounting component with a pin spacing of 8.25 mm, ideal for applications in power supplies, industrial equipment and control systems. Its solid construction and durable materials ensure reliable wire connections and resistance to harsh operating conditions.

Female terminal block, 10-pin. Pitch 5.0mm. Height 15mm. Suitable for 2EDGRC male strips with a pitch of 5.0 mm. 2EDGKN-5.00

Development board D1 Mini with WiFi module ESP-8266MOD and 4 MB Flash memory. The module can be programmed from the Arduino IDE level. WeMos D1 Mini

GPS module with LC29H GNSS receiver designed to work with the Raspberry Pi minicomputer. It allows you to receive data from major positioning systems, including GPS, QZSS, GLONASS, Galileo and BeiDou, and supports fast, dual-band RTK positioning. Waveshare LC29H(DA) GPS/RTK HAT

Precision test lead with a green crocodile clip, designed for laboratory, service and testing applications, 45 cm long and PVC insulated. Made of durable materials, it guarantees reliable electrical connections, even in hard-to-reach places.

RS485 CAN HAT is an extension designed for the Raspberry Pi mini-computer in the form of a HAT overlay. Adds RS485 and CAN interfaces for the Raspberry Pi plate. Interface signals are derived as screw and goldpin connectors. RS485 CAN HAT