Category: Amplifier modules
There are 134 products.
Module with the WM8960 audio codec, which allows you to operate 1 W stereo speakers and two microphones via the I2S interface. Waveshare WM8960 Audio HAT
BOB-11044 OSHWTPA2005D1 class D audio amplifier module. The chip can work with a loudspeaker up to 1.4 W and 8 Ohm. SparkFun BOB-1104
WM8960 stereo codec module with driver for 1W class D speakers and headphones. It uses the I2S interface and the I2C bus to configure the system. SparkFun BOB-21772
Module with class D mono audio amplifier designed for QT Py and Xiao boards. It is based on the MAX98357 system and can work with a loudspeaker from 4 to 8 Ω with a power of up to 3 W. It communicates via the I2S interface. Adafruit 5770
LM386 audio amplifier module. It is supplied with the voltage ranging from 4 to 12 V. The set includes an 8 Ω, 0.5 W loudspeaker. DFRobot DFR0064
HiFi stereo tube amplifier based on 6J1 and 6P1 tubes. Designed for use with loudspeakers up to 3 W and an impedance of 4 Ω or 8 Ω
Class A power amplifier with two channels, 45 W. Built on the popular J. Hood design from 1969
Stereo audio amplifier with a power of 40 W (2 x 20 W) powered with the voltage of 12 V. Equipped with an audio input in the form of two chinch sockets and an audio jack 3.5 mm input
A module with an active low-pass filter based on NE5532 systems. Dedicated to the bass column (subwoofer)
The board has a class D amplifier onboard that can drive 2 channels of 4-8 ohm impedance speakers at 20W each. Adafruit 1752
Class D digital audio amplifier with Bluetooth 5.0 module. It has two channels with a power of 300 W and can work with 4 Ω speakers. Powered by alternating voltage 230 V
Class AB audio amplifier with three output channels. It can be powered with AC voltage from 8 to 18 V and has two outputs with a power of 18 W (left and right) and one with a power of 20 W (bass)
Audio amplifier based on the TPA3255 system with a power of 600 W with an active filter. Dedicated to the bass column (subwoofer)
An audio module with a DAC converter and a stereo amplifier designed to work with the Raspberry Pi. Adafruit 3346
Stereo tube preamplifier based on 6J3 tubes. Designed for use with active speakers or an additional amplifier and passive speakers
A stereo tube preamplifier based on 6K4 tubes. Designed for use with active speakers or an additional amplifier and passive speakers. SUCA-AUDIO TUBE-T1
Module with two operational amplifiers OPA627
Audio amplifier with three output channels. It can be powered with the voltage from 12 to 24 V and has two outputs with a power of 50 W (left and right) and one with a power of 100 W (bass). Equipped with Bluetooth 5.0 communication
Class-D stereo digital audio amplifier module PAM8403. The system allows you to connect two speakers with an impedance of 4 to 8 Ω and a power of 3 W. DFRobot DFR0119-O