Category: Main categories
Subcategories
There are 23381 products.
FPC/FFC 50-pin adapter with 0.5mm pitch for DIP holes 2.54mm pitch.
The 13.56 MHz RFID reader module in a set with a keyring and RFID card
Female terminal block, 12-pin. Pitch 3.5mm. Height 7.8mm. Suitable for KF2EDGR male strips with a pitch of 3.5 mm. 2EDGKN-3.5
M74HCT02M1R, quad 2-input open drain NOR gate, SO14
JST SH type connector, 1.0 mm pitch, surface mounted, horizontal spatial orientation. The set includes 10 connectors
NC-519 8p is a durable panel-mount microphone connector, offering 8 signal channels, solder wire termination, and IP55 protection, making it a suitable solution for use in demanding environmental conditions.
High voltage amplifier for current measurement on a shunt resistor in a TSSOP-8 housing. STMicroelectronics TSC103IYPT
Female terminal block, 12-pin. Pitch 3.81mm. Height 7.8mm. Suitable for 15EDGRC male strips with a pitch of 3.81 mm. 2EDGKN-3.81
CAN module based on the SN65HVD230 system, allows you to connect a microcontroller with a CAN bus interface
Female terminal block, 4-pin. Pitch 3.5mm. Height 7.8mm. Suitable for KF2EDGR male strips with a pitch of 3.5 mm. 2EDGKN-3.5
Antenna with RP-SMA male plug operating in the 433 MHz frequency band. It has a gain of 5 dBi. Included with RP-SMA - u.FL adapter
WiFI 802.11 b/g/n module. Equipment includes, among others: LED diode, antenna, 8 pins with 2.54mm pitch (including 3 GPIO lines). Power supply: 3.3V.
Membrane keypad module with 4 buttons. It is equipped with a tape terminated with a 5-pin connector
M74HCT257M1R, quad 2 channel multiplekser, 3-state, SO16
Female terminal block, 8-pin. Pitch 5.0mm. Height 15mm. Suitable for 2EDGRC male strips with a pitch of 5.0 mm. 2EDGKN-5.00
Espressif ESP32-S3 WiFi and Bluetooth LE module board. It offers 16 MB of flash memory and 2 MB of SRAM. The pinouts are compatible with the HAT modules for the Raspberry Pi Pico. Waveshare ESP32-S3-Pico
Cabel USB-A - USB-B 2.0 0,5m, Black, Lanberg, CA-USBA-10CC-0005-BK