Cytron Maker Nano - Arduino compatible board

A compact board similar to Seeeduino V4.2/Arduino UNO and fully compatible with Arduino Nano. It uses a USB Type C connector and a Grove I2C connector. Seeed Studio 102010268

Development board with ATmega328P microcontroller compatible with Arduino Uno Rev3. Waveshare R3 PLUS

Module with ATmega328 microcontroller from the AVR family (32 kB Flash, 2 kB SRAM, 1 kB EEPROM). The module has 14 I/O lines, 6 PWM channels, 8 analog inputs

Board with Atmel ATmega328 microcontroller from the AVR family, there are 14 I / O lines, 6 PWM channels and 6 analog inputs. The additional ATmega16U4 microcontroller realizes communication via the USB interface

Virtual keyboard module in the form of a small flash drive. It allows you to simulate the keyboard after uploading the appropriate software and pressing a combination of buttons on the computer.

Microcontroller board based on the ATmega328P

The board is compatible with Arduino, based on the ATmega328P microcontroller from the AVR family, 14 I/O lines, 6 PWM channels, 6 analog inputs are available to the user. The CH340G chip communicates via a USB interface. In addition, it has 12 LEDs, a programmable button and a embedded buzzer. Cytron Uno Maker

Board compatible with Arduino, based on ATmega328P. Equipped with an area with prototype holes, a breadboard, 12 LEDs, a button and a buzzer. Cytron MAKER-UNO-X

Module with ATmega4808 microcontroller from AVR family (48 KB Flash, 6 KB SRAM, 256 B EEPROM). The module has 14 I / O lines, 6 PWM channels, 8 analog inputs.

Equipped with an equivalent Atmel ATmega328 microcontroller from the AVR family, the board offers 14 I/O lines, 6 PWM channels, and 6 analog inputs. An additional chip communicates via the USB interface

Development board equipped with RP2040 microcontroller, RGB LED diodes, buzzer and Qwiic/STEMMA QT connectors. Pin spacing compatible with Arduino Nano. Cytron MAKER-NANO-RP2040

Board compatible with Arduino, equipped with the ATmega32U4 microcontroller

The board is equipped with ATSAMD21 microcontroller with ARM Cortex-M0 core. It has connectors and dimensions compatible with the Arduino Uno Rev3. HW-819

A miniature development board with ATtiny85 microcontroller, on which 6 I / O pins were derived. The module is supported by Arduino IDE. modATT85

Compact microcontroller board with an ATmega32U4 chip that integrates with USB to act as a HID device such as a keyboard or mouse. It operates at 5V at 16MHz, offering 20 digital I/O lines, of which 7 support PWM and 12 act as analog inputs.

Board with Atmel ATmega328P microcontroller from the AVR family, there are 14 I / O lines, 6 PWM channels and 6 analog inputs. The additional ATmega16U4 microcontroller realizes communication via the USB interface