Best sellers

The board with prototype holes is dedicated to the Raspberry Pi Pico. It offers an area of 6x20 holes and two areas of 8x20 holes with a pitch of 2.54 mm with marked pin labels. SB Components 21505

Single-core, multi-strand wire in blue silicone insulation. 18AWG thickness, 4m length

Single-core, multi-strand wire in black silicone insulation. 18AWG thickness, 4m length

Kit includes 6 spools of yellow, green, red, blue, black and white wires with silicone flexible insulation. The set also includes heat shrink tubing, cable ties, insulation stripper and insulation tape

Red laser diode module with 5mW power, displaying intersecting lines. Ideally suited to the construction of the laser level, and thanks to the built-in driver, it is possible to power 3 - 5V. LD-G650A03 - Cross

Engraving cutter for PCBs with a blade diameter of 0.4 mm. V-shape with 10° blade angle, handle diameter 3.175 mm

The ring has sixteen RGB WS2812 diodes, controlled by means of serial signals. The module can be supplied with voltage from 4-7V, only one signal line is required to control it. NeoPixel Ring 16 x WS2812

Brushless DC motor driver (BLDC) with speed regulation by potentiometer or PWM signal. It can operate motors powered with the voltage from 6 to 60 V with a current consumption of up to 16 A

2.4 "TFT LCD display module with SD card slot. Resolution 240x320. Based on the ILI9341 controller. Powered by 3.3V or 5V.

Cable (adapter) with a female DC 5.5x2.1 mm connector and alligator clips. It allows you to conveniently connect the device, e.g. to a power supply

ATTINY44A-PU

ATtiny44A-PU is a microcontroller from the AVR family in the DIP14 housing, it is equipped with memory: 2 kB Flash, 128 B SRAM, 128 B EEPROM. The power supply voltage is 4.5..5.5 V, the maximum clock speed is 20 MHz.

The third hand ZD-10H is a mounting bracket with a magnifying glass 2.5 times on a cast iron stand

Adapter from DC 5.5 x 2.1 mm male connector to terminal spring connector

Set of 6 wire spools in yellow, green, red, blue, black and white with silicone flexible insulation

Kit includes 6 spools of yellow, green, red, blue, black and white wires with silicone flexible insulation. The set also includes heat shrink tubing, cable ties, insulation stripper and insulation tape

Adapter from male RCA connector to terminal spring connector

Non-contact, capacitive liquid level sensor with flexible probe. It allows you to detect the presence of, among others water in non-metallic containers. DFRobot SEN0508

Programmable standard 17kg * cm servo controlled by UART interface. It can work in the rotation angle control mode or in the continuous operation mode. Waveshare SC15 Servo

Module with CO2, temperature and humidity sensor SCD-41. Equipped with a Qwiic/STEMMA QT connector, it communicates via the I2C interface. Pimoroni PIM587

I2C multiplexer module with TCA9548A system. Allows you to connect up to 8 devices. The system works like a gateway - it transmits I2C interface data to one of the 8 main busses. This allows you to connect up to 8 devices with the same address. Adafruit 2717