Best sellers

Ethernet network cable UTP Cat6 unshielded patchcord, 2 m long, white, with 2xRJ45 connectors. Lanberg PCU6-10CC-0200-S

Set of M.2 connectors for MicoMod modules. Necessary when designing your own expansion board. SparkFun KIT-16549

Espruino module with Bluetooth LE based on MDBT42Q system with Nordic Semiconductor nRF52832 microcontroller. The module has a pre-installed JavaScript interpreter. Adafruit 3876

Universal multimeter allows you to measure direct and alternating voltage, direct and alternating current, resistance, capacity. Equipped with diode tester, circuit continuity test, automatic circuit breaker. Uni-T UT58A

Easy PET-G filament in red with a diameter of 1.75 mm. 0.85 kg of filament is wound on a spool. Fiberlogy Easy PET-G Red

The S9V11MACMA switching step-up/step-down regulator efficiently produces a finely adjustable output between 2.5 V and 9 V whether it is higher or lower than the input voltage, which can range from 3 V to 16 V. The regulator also has a precision-adjustable low-voltage cutoff with hysteresis that can be used to prevent battery over-discharge.

Module with a TDS sensor that allows you to measure the total content of solids dissolved in water. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020753

Module with replaceable LED diodes in 4 colors: red, green, blue and white. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104020228

RGB LED strip with SMD 5050 diodes. It is powered by 12 V DC, has a length of 5 m and 120 LEDs/m. Protection class IP65 (waterproof)

The S9V11F3S5C3 switching step-up/step-down regulator efficiently produces a fixed 3.3 V (default) or 5 V (selectable) output whether it is higher or lower than the input voltage, which can range from 3 V to 16 V. The regulator also has fixed 3.3 V low-voltage cutoff with hysteresis that can be used to prevent battery over-discharge.

The S9V11F5S6CMA switching step-up/step-down regulator efficiently produces a fixed 5 V (default) or 6 V (selectable) output whether it is higher or lower than the input voltage, which can range from 2 V to 16 V. (Note: minimum start-up voltage is 3 V, but it operates to 2 V after that.)

Blue LED strip with SMD 5050 diodes. It is powered by 12 V DC, has a length of 5 m and 60 LEDs/m. Protection level IP21

Connect your Arduino-compatible to the Internet with this WiFi shield that features the FCC-certified ATWINC1500 module from Atmel. Adafruit 3653

Power supply dedicated to the Build HAT module for the Raspberry Pi. It has an output voltage of 8 V and a DC 5.5 x 2.1 mm connector. Raspberry Pi SC0748

Tool box 20 "with a module with 3 storage containers.

2S Li-Po battery charge indicator module with a nominal voltage of 8.4 V

Module with DC motor driver DRV8876. It can work with motors supplied with the voltage from 4.5 to 37 V and the current consumption up to 1.3 A. Pololu 4036

12 "tool box with a removable tray with a bit holder and additional organizers for storing small items.

The FS5106R is a standard-sized servo that has been built by FEETECH specifically for continuous rotation, making it an easy way to get your robot moving. It features two ball bearings on the output shaft for reduced friction, and it offers easy access to the rest-point adjustment potentiometer.