Best sellers

Silicone solder mat resistant to high temperatures. It can be used as a table pad during soldering and repair work

USB tester for precise monitoring of the performance of devices connected to the USB port. Allows recognition of fast charging modes and monitoring and conversion of PD modes. Fnirsi FNB38

Silicone solder mat resistant to high temperatures. It can be used as a table pad during soldering and repair work. Equipped with fields with magnets

Black metal casing for Raspberry Pi 4 model B minicomputers. Equipped with active cooling ICE Tower Low Profile

Silicone solder mat resistant to high temperatures. It can be used as a table pad during soldering and repair work. Equipped with fields with magnets and lockable compartments

USB tester for precise monitoring of the performance of devices connected to the USB port. It can recognise fast charging modes and monitor and convert PD modes. It has built-in Bluetooth communication and a metal housing. Fnirsi FNB58

LiPo and LiFePO4 battery charger module based on the TP5000 chip. It can handle batteries charged with 4.2 V and 3.6 V with the default charging current of 1 A

Brush for cleaning nozzles in 3D printers. Made of brass wire, it facilitates the maintenance and service of 3D printers

A needle with a diameter of 0.2 mm, designed for cleaning the nozzle in 3D printers. It allows you to get rid of the remnants of the material after printing and to remove the filament in case of clogged nozzle

A needle with a diameter of 0.3 mm, designed for cleaning the nozzle in 3D printers. It allows you to get rid of the remnants of the material after printing and to remove the filament in case of clogged nozzle

A needle with a diameter of 0.35 mm, designed for cleaning the nozzle in 3D printers. It allows you to get rid of the remnants of the material after printing and to remove the filament in case of clogged nozzle

A needle with a diameter of 0.5 mm, designed for cleaning the nozzle in 3D printers. It allows you to get rid of the remnants of the material after printing and to remove the filament in case of clogged nozzle

Ionising radiation detector (a.k.a. dosimeter or Geiger counter). It is used to measure the dose of ionising radiation, i.e. the amount of energy that is absorbed by an organism or material during exposure to radiation. It is capable of detecting three types of radiation: X-rays (X-rays), Y-rays and β-rays. Fnirsi GC-01

Large heat sink for Raspberry Pi 4 model B minicomputers. It is made of aluminum alloy and allows for proper cooling of the components on the board

The charger module is designed for 3 Li-Ion cells. It is equipped with a micro USB and USB type C connector and supports fast charging (QC).

Straight male socket, wire-plate type, for JST PH-2.0 wires, 6-pin, 2mm pitch, 100V, 2A. Set of 10 pieces

Heatsink designed for mounting on Raspberry Pi CM4 modules. Komaptybilny with base boards Compute Module 4 IO Board and Compute Module 4 PoE Board. Waveshare CM4-HEATSINK

BMS protection circuit designed for 6 Li-Ion cells. It has a charging function with balancer option, a discharging function and an over-discharge protection function. HXYP-C47-MA18-6S

Aluminium heating block dedicated to E3D V6 nozzles. Provides effective and even heating of the print nozzle. Does not have a hole for a thermistor with mounting pad, but instead has a hole for a PT100 sensor

Module with electret microphone and LM393 amplifier that will allow you to detect voice, clap, slam doors and other sounds using analog or digital output