Best sellers
There are 16723 products.
Dreamer Nano V4 - Arduino Leonardo compatible; ATmega 32U4
Module with 6-axis BMI160 motion sensor (accelerometer and gyroscope) with 16-bit data resolution. It is supplied with the voltage in the range from 3.2 to 6 V. I2C communication. DFRobot SEN0250
A module with a set of environmental sensors (pressure, temperature and humidity sensor, light sensor, MEMS microphone) and an LCD display for Raspberry Pi minicomputers. Pimoroni PIM486
8-digit, 8-segment LED display module with 16-level brightness adjustment. Communication via the I2C interface. DFRobot DFR0646-G
Aluminum Standoff: 1/8" Length, 4-40 Thread, F-F (4-Pack)
A pin expander designed for Raspberry Pi Pico boards. It is equipped with a standard female connector and two sets of male strips 2x20 pins. Pimoroni PIM556
Nylon Spacer: 10mm Length, 4mm OD, 2.7mm ID (25-Pack)
Nylon Spacer: 12mm Length, 4mm OD, 2.7mm ID (25-Pack)
Lens with CS-mount and 3.2 mm focal length with a very wide angle of view of 120°. Designed to work with the Raspberry Pi HQ camera. ArduCAM LN051
Integrated BME688 gas, pressure, temperature and humidity sensor in one MEMS housing. The system can be supplied with the voltage of 3.3 V and is equipped with an I2C communication interface. BME688 Breakout Board
Module with an analog AC current sensor in a set with a probe for non-contact measurement of alternating current with a current of up to 5A. DFRobot SEN0287
A small module - an infrared emitter (LED IR). The diode emits infrared light with a wavelength of 940 nm. With the help of the module, it is possible to transmit commands or signals that can be received by an infrared receiver. The transmission range is up to 10 meters. Seeed studio 101020026
STM32 Nucleo-144 development board with STM32F722ZE MCU, supports Arduino, ST Zio and morpho connectivity
Set with the ADC HX711 transducer module and a pressure sensor in the form of a tensometric beam. It communicates via the UART interface. It allows you to build a simple home scale. DFRobot SEN0160
Module with tact switch button. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 101020003
Module with a sound sensor based on an electret microphone and LM358 amplifier. The board is equipped with a Grove connector and communicates via an analog interface. Seeed Studio 101020023
The sensor is designed for indoor air quality testing. The main gas detected is carbon monoxide, alcohol, acetone, thinner, formaldehyde and other slightly toxic gases. It is compatible with 5V and 3.3V power supply. Seeed Studio 101020078
Flat USB cable A - micro-B USB with 1m length, cable in black
Force-Sensing Resistor - 0.2" Circle
Step-Down converter with an output voltage of 5 V, an input voltage of 6.5 to 16 V and a maximum current of 4 A