Best sellers

Three-way crossover with a crossover frequency of 1000 Hz and 5000 Hz. It works with speakers with an impedance of 5 to 8 Ω and offers power up to 180 W

Three-way crossover with a crossover frequency of 900 Hz and 5000 Hz. It works with speakers with an impedance of 5 to 8 Ω and offers power up to 150 W

Laser distance sensor with a measurement range of 0.1 m to 12 m dedicated to indoor use. It communicates via UART or I2C interface. Benewake TFmini Plus Indoor

QUICK Q-T-2B series soldering tip designed for use in: 236/706/936A/3104/3102/TS1100

32-bit microcontroller with ARM Cortex-M0 core, XMC1200, 32kB Flash, TSSOP-16, Infineon

The HQ-192 sucker is used to remove excess tin. NAR0019

10 DoF module with ADXL345 accelerometer, HMC5883L magnetometer, ITG-3205 gyroscope and BMP280 barometer. Communication via the I2C interface. DFRobot SEN0140

Module with Flash memory W25Q64 with a capacity of 64 Mbit (8 MB). It communicates via the QSPI interface. Adafruit 5633

Antenna with an SMA male connector working in the 868 MHz frequency band. It has a gain of 5 dBi and the tip at right angles

Module with Flash memory W25Q128 with a capacity of 128 Mbit (16 MB). It communicates via the QSPI interface. Adafruit 5634

Module with a 3-axis ADXL345 digital accelerometer with a configurable measuring range of ± 2/4/8/16 g. It is supplied with the voltage from 2 to 3.6 V and communicates via the I2C or SPI interface. DFRobot SEN0032

Probe for measuring direct and alternating current up to 30 A. Works in the band up to 50 MHz, can be connected to the oscilloscope through the BNC connector. Powered by USB. Micsig CP503B

Probe for measuring direct and alternating current up to 30 A. Works in the band up to 100 MHz, can be connected to the oscilloscope through the BNC connector. Powered by USB. Micsig CP1003B

Switching power supply with 35 W, 24 V output voltage and 1.5 A current. It has built-in overload and short-circuit protection and a low profile housing. Mean Well LRS-35-24

Crossover for woofers with a division frequency of 300 Hz. Works with 4 to 8 ohm speakers and offers up to 200 watts of power

Two-way speaker crossover with a dividing frequency of 2800 Hz. Works with 4 to 8 ohm speakers and offers up to 350 watts of power

Two-way speaker crossover with a division frequency of 2500Hz/3000Hz. Works with 4 to 8 ohm speakers and offers up to 250 watts of power

Adafruit 2097 - PiTFT - Assembled 480x320 3.5" TFT+Touchscreen for Raspberry Pi

A kit for building a minicomputer based on the Raspberry Pi CM4. It consists of a metal case with a fan, a power supply and a WIFI6 Dual ETH Base Board. Waveshare CM4-DUAL-ETH-WIFI6-BOX (EU)