Best sellers

4-wire cable, 30 cm long, with a JST PH-2.0 female plug at one end

2-wire cable, 30 cm long, with a JST PH-2.0 female plug at one end

Soldering station with digital temperature control ranging from 180 to 450°C and digital display. Equipped with a 50 W soldering iron and a stand. Bakon BK950D

The camera set with the Sony IMX477 sensor allows you to remotely control zoom. Works with all versions of the Raspberry Pi. The camera is equipped with a matrix with a resolution of 12 MPx. ArduCAM B016712MP

Power cord with a length of 45 cm with a male XT60 plug and a DC Jack 5.5 x 2.5 mm plug. It allows you to connect a battery with an XT60 socket to a device with a DC socket

LED diode 10LED two-colored - bargraph, ultra-10mcd (4mA) - max: 40mcd (20mA), ultragreen 10mcd 4mA) - max: 40mcd (20mA)

Ethernet module designed for Teensy 4.1. The board has an Ethernet connector and a 6-pin connector for connecting to Teensy. PJRC ETHERNET-KIT

Audio module designed for Teensy 4.0 and 4.1. It uses the SGTL500 audio codec chip with I2S interface, it can work with a microSD card or SPI Flash memory. Audio Adapter Boards for Teensy 4.x (Rev D)

8 MB PSRAM memory chip, designed for mounting on Teensy 4.1 boards. It enables the expansion of the memory of the microcontroller. PJRC IC-PSRAM-8MB-SOIC8

LED diode 10LED red - bargraph, replacement for: DC-10EWA

Antenna with MCX male connector operating in the 1090 MHz frequency band. It has a gain of 3.5 dBi and a 1 m cable. Magnetically attached

LED diode 10LED two-colored - bargraph, ultra-10mcd (4mA) - max: 40mcd (20mA), ultragreen 10mcd 4mA) - max: 40mcd (20mA)

Mini-flat Package, General Purpose Photocoupler, Mini-Flat4, Sharp Microelectronics

A set of 40 pcs of male-male connecting cables in various colors, 10 cm long

Angled male socket, wire-board type, for JST PH-2.0 wires, 10-pin, 2mm pitch, 100V, 2A. Set of 10 pieces

Wireless communication module based on the NRF24L01 chip. It is designed for SMD mounting and will be perfect for the construction of small devices

Step-Up converter with an output voltage of 2 to 28 V, an input voltage of 2 to 24 V and a maximum current of 2 A

A needle with a diameter of 0.35 mm, designed for cleaning the nozzle in 3D printers. It allows you to get rid of the remnants of the material after printing and to remove the filament in case of clogged nozzle