Best sellers

The Digilent Cmod A7 is a small, breadboard friendly 48-pin DIP form factor board built around a Xilinx Artix-7 FPGA. The board also includes a USB-JTAG programming circuit, USB-UART bridge, clock source, Pmod host connector, SRAM, Quad-SPI Flash, and basic I/O devices. 410-328

The MQ-8 module allows the measurement of hydrogen concentration in the air. It has an analogue output and an output triggered by exceeding the threshold of sensitivity.

Needle bending needle, for precise glue application, Flux 1,372mm internal diameter and 1,829mm outside diameter. Set of 5 pcs

The Step-Up / Step-Down S18V20F12 inverter module gives the output voltage of 12V with a wide input voltage range of 3 ... 30V and a maximum output current of 2A. Polol 2577

Module with 9-axis IMU. It combines the ISM330DHCX (accelerometer and gyroscope) and MMC5983MA (magnetometer) systems. Communication via the I2C interface. SparkFun SEN-19895

Development board with ESP32 chip with WiFi and Bluetooth communication. Equipped with a microSD card slot, USB Type-C connector for programming and Ardunio Uno Rev3 compatible connectors and Qwiic connector. SparkFun WRL-19177

Permanent cylindrical neodymium magnet with a diameter of 4 mm and a height of 2 mm. Set of 10 pcs

Stereo audio amplifier based on the TPA3116D2 chip. It can be powered with the voltage from 12 to 24 V and has two outputs with a power of 100 W

Neodymium rectangular magnet with dimensions of 3x3mm a and a height of 3 mm. Set of 10 pcs

GT2 belt 10 mm wide. Used as a drive transmission element in small devices such as a plotter or 3D printer

QTR-1RC Reflectance Sensor (2-Pack)

2-wire cable with JST plug, cable ends are tinned, length 15 cm, 2mm pitch. The cable has an additional 2-pole angled cable-to-board socket

Neodymium rectangular magnet with dimensions of 30x5mm a and a height of 3 mm. Set of 5 pcs

Neodymium rectangular magnet with dimensions of 30x10mm a and a height of 3 mm. Set of 5 pcs

Toggle switch, two-position with cover and LED illumination. It can switch voltage up to 12 V and current up to 20 A

GT2 belt 6 mm wide. Used as a drive transmission element in small devices such as a plotter or 3D printer

Module with a DC motor driver based on the MC33886 chip. It allows you to control the movement of drives with a working voltage from 5 to 28 V and a current of up to 5 A

Universal expansion board with screw connectors dedicated to Raspberry Pi Pico. Facilitates the creation of device prototypes