CR10 hotend kit

Cooling fan powered with the voltage of 5 V with a lead out a cable with a two-pin connector with a pitch of 2.54 mm

Pulley GT2 36T B8 for a shaft with a diameter of 8 mm. It has 36 teeth, suitable for a 6mm wide belt

Temperature sensor in the form of a HT-NTC100K thermistor on a 1 m cable. Designed for 3D printers

MK8 complete hotend head kit for the Creality Ender and CR10 3D printer. It is equipped with a 0.4 mm print nozzle

Flexible coupling for shafts with a diameter of 5 mm and 6 mm. It is made of aluminum, has a diameter of 19 mm and a length of 24 mm

Nut with M4 thread for screwing the table to the 3D printer

GT2 belt 6 mm wide. Used as a drive transmission element in small devices such as a plotter or 3D printer

Silicone pad with a working temperature of up to 200°C. Used to level tables in 3D printers as an alternative to a set of springs

High flow adapter for E3D V6 nozzle, which allows you to connect a nozzle to increase the heating surface of the filament

Ceramic heater designed for installation in the heating block of a 3D printer. Power 50 W, powered by 12 V

Bearing GT2 pulley for shaft diameter 5 mm. It has 20 teeth, suitable for a 6mm wide belt

Pulley GT2 36T B5 for a shaft with a diameter of 5 mm. It has 36 teeth, suitable for a 6mm wide belt

Flexible shaft coupling with a diameter of 8 mm and 10 mm. It is made of aluminum, has a diameter of 25 mm and a length of 30 mm

Threaded pipe used to connect the heat sink and heating block, contains a Teflon tube in the middle, adapted to a 1.75 mm filament

Flat tape for Flashforge Creator Pro printer connecting the control panel with the motherboard. Flashforge FF-FC-CP

Pulley GT2 40T B5 for a shaft with a diameter of 5 mm. It has 40 teeth, suitable for a 6mm wide belt