Aluminium heating block for V6 nozzles

Flat tape for Flashforge Creator Pro printer connecting the control panel with the motherboard. Flashforge FF-FC-CP

Silicone pad with a working temperature of up to 200°C. Used to level tables in 3D printers as an alternative to a set of springs

Pulley GT2 60T B5 for a shaft with a diameter of 5 mm. It has 60 teeth, suitable for a 6mm wide belt

Pulley GT2 30T B8 for a shaft with a diameter of 8 mm. It has 30 teeth, suitable for a 6mm wide belt

Connector for fixing Teflon tubes in pneumatic systems. It is also used in 3D printing, where it is used to attach the filament supply tube to the print head

Bimetallic heatbreak dedicated to the Ender CR6 SE. Avoids clogging of the head

Pulley GT2 36T B5 for a shaft with a diameter of 5 mm. It has 36 teeth, suitable for a 6mm wide belt

Aluminium heating block dedicated to E3D V6 nozzles. Provides effective and even heating of the print nozzle. Does not have a hole for a thermistor with mounting pad, but instead has a hole for a PT100 sensor

Ceramic heater designed for installation in the heating block of a 3D printer. Power 50 W, powered by 12 V

The CR10 complete hotend head kit for the Creality Ender 3, Ender 5, CR10 and CR10S 3D printer. It is equipped with a 0.4 mm print nozzle

Pulley GT2 36T B6.35 for a shaft with a diameter of 6.35 mm. It has 36 teeth, suitable for a 6mm wide belt

Pulley GT2 40T B5 for a shaft with a diameter of 5 mm. It has 40 teeth, suitable for a 10mm wide belt

Pulley GT2 40T B6.35 for a shaft with a diameter of 6.35 mm. It has 40 teeth, suitable for a 6mm wide belt

Volcano adapter for E3D V6 nozzle, which allows the use of shorter nozzles on heads adapted to the longer Volcano nozzles

MK8 complete hotend head kit for the Creality Ender and CR10 3D printer. It is equipped with a 0.4 mm print nozzle

Threaded pipe used to connect the heat sink and heating block, contains a Teflon tube in the middle, adapted to a 1.75 mm filament