Shunt regulator 4 ... 18V, 1.5 Ohm, 15W

SEN-11769

USB-UART TTL converter based on the CH343G chip. Equipped with a number of security features ensuring stable and safe communication. Waveshare CH343 USB UART Board (type C)

Module with 4 5 V relays with a maximum switching current of 2 A. It communicates via the USB interface and does not require an additional power supply. Numato Lab USBPOWRL004

Bidirectional current sensor module based on the ACS724 circuit. It allows you to measure current in the range -50A to + 50A. It operates with a voltage of 4.5V to 5.5V and is intended for use in 5V systems. Pololu 4049

8-channel IO expander with 6 analog inputs. It communicates via the USB interface. Version without Pull-Up resistors. Numato Lab GP80001

Camera module with a resolution of 13 MP with a USB 2.0 interface. It is equipped with an IMX258 sensor and optical image stabilization. Waveshare WSH IMX258 13MP OIS USB Camera (A)

USB - RS232/RS485 converter equipped with the original FT232RNL system. The housing is made of industrial ABS, making it a versatile tool for various industrial and commercial applications. Waveshare USB TO RS232/485 (B)

Module with bi-directional current sensor based on the INA226 system. It allows you to measure current and power, works with a voltage of 0-36 V. It has an I2C interface.

A module with an active low-pass filter based on NE5532 systems. Dedicated to the bass column (subwoofer)

Module with an AB class amplifier based on the Boomer® LM4853 system. It can work in two modes: mono (power 1.5 W, load 4 Ω) or stereo (power 300 mW, load 8 Ω). It has a potentiometer for power control and gain control for the left and right channel. SparkFun DEV-14475

Module with 4 relays with a maximum switching current of 7 A. Equipped with the ATmega328P microcontroller, it can be programmed in the Arduino IDE. Numato Lab PRLY002

Module with 64 relays and 8 GPIO pins and 6 analog inputs. It communicates via the RS485, USB or Ethernet interface and supports the Modbus RTU/TCP protocol. Numato Lab NLRM1003-A

TB6612FNG dual DC motor controller module. It can be used as a stepper motor driver or solenoid driver. Adafruit 2448

This add-on board makes it easy to control two high-power DC motors with a Raspberry Pi. Its twin discrete MOSFET H-bridges support a wide 6.5 V to 30 Voperating range and are efficient enough to deliver a continuous 18 A without a heat sink. The drivers offer basic current limiting functionality, and they accept ultrasonic PWM frequencies for quieter operation. 

A stepper motor controller that can operate with a voltage range of 24 to 110 VDC or 18 to 80 VAC and a maximum current of up to 8.4 A. It allows micro step configuration in the range of 2 to 256. 2DM860H

3V/5V voltage level converter module with built-in Step-Up converter. Allows development boards operating at 3V to be connected to a device requiring a higher operating voltage of 5V for I2C communication. Adafruit 5649