HDMI (F) - DVI (M) adapter

RTC real time clock plate enables precise timing, is equipped with PCF8563.MOD-74

Adapter enabling easy and quick connection of Modular DuoNect expansion modules with a ribbon cable with an IDC connector. MOD-83

White 1206 LED, RoHS

16-channel GPIO expander with an I2C interface microcontroller can interface with 16 fully configurable digital input/output pins. It can produce PWM signals, so you can dim LEDs. It can be set to blink or even breathe pins at varying rates. With a built-in keypad engine, it can interface with up to 64 buttons set up in an 8x8 matrix. BOB-13601

The DFRobot Vibration Sensor buffers a piezoelectric transducer that responds to strain changes by generating a measurable output voltage change which is propotional with the strength of vibration. DFR0052

Vibrating sensor module, Plug & Play, omni-directional, designed for switching over low-current circuits. DFRobot DFR0027

This 50pin FPC extension board has two 50-pin flex connectors, and an extension cable to add ~22cm (20cm cable plus 2cm board)  Each order comes with one board a 20cm long, 50-pin 0.5mm pitch FPC cable and board. Adafruit-2571

The Texas Instruments H-bridge allows control of two DC brush motors or one stepper motor. The supply voltage of the motor is in the range of 0-11V, maximum current efficiency 1.5A / bridge. The system has a 12WSON housing

Expander (shield) compatible with Arduino and NUCLEO (STM32) systems, equipped with a Bluetooth 4.1 (BLE) radio module from the SPBTLE-RF family

A small USB 2.0 hub that allows you to disable individual devices connected to its USB ports, as well as a visual evaluation of the number of devices enabled. It has a built-in connector for the external power supply, so it can act as an active hub. Cable with a length of 40cm, 4 USB ports

A small USB 2.0 FS hub that allows you to disable individual devices connected to its USB ports, as well as a visual evaluation of the number of devices enabled. It has a built-in connector for the external power supply, so it can act as an active hub. Cable with a length of 40cm, 7 USB sockets

USB splitter allowing to connect up to 4 USB devices. It has a cable with a length of 80cm, a power indicator and the possibility of powering from an external source with a microUSB connector

A four-port USB 2.0 hub that allows data transfer at speeds up to 12Mbit / s. It has a black housing and a 45cm long cable

The cable allows you to attach a USB device (eg keyboard, mouse, Flash memory) to the device with microUSB OTG connector. The cord has a length of 14cm

Blue USB 3.0 A cable - microUSB 3.0 B with 1m length, allowing SuperSpeed transmission (up to 5Gbit / s = 625MB / s)

Tilt Sensor