Products
Categories
- Main categories
-
- 3D PRINTING
- ACADEMIC OFFER
- ARDUINO
- AUTOMATION
- BOOKS
- DIY KITS
- AVT kits
- Audio
- Car
- Chargers
- Clocks, timers and schedule switches
- Communication
- Converters
- Development kits and modules
- Displays
- Electronic games
- Generators
- Hobbies and fun
- House
- Interfaces
- Light effects
- meters
- PC
- Power Supplies
- Pre-programmed circuits
- Printed circuit boards (PCB)
- Programmers
- Regulators, controllers
- Remote control
- Starter sets Ośla Łączka
- Starting sets for beginners
- Workshop tools
- Audio
- Other sets
- TOP-Q kits
- Totem
- UGears
- Velleman
- AVT kits
- EBOOKS
- ELECTRONICS
- Cables
- Cameras and accessories
- Communication
- Conductive materials
- Connectors
- ARK connectors (Terminal Block)
- Coaxial connectors (RF)
- Connectors
- Crocodile clip
- D-Sub drawer connectors
- DC power connectors
- FFC/FPC ZIF connectors
- Goldpin connectors
- IDC connectors
- JACK connectors
- JST connectors
- Jumpers
- Memory cards slots
- Other connectors
- Pogo pin
- RJ45 sockets
- Slip ring connector
- Supports
- Szybkozłącza
- USB connectors
- Cooling
- Displays
- Electronic modules
- A/D and D/A converters
- Audio
- Barcode readers
- CAN converters
- Converters USB - UART / RS232
- Data logger
- DDS/PLL generators
- Digital potentiometers
- Encoders
- Expanders of the I/O
- Fingerprint readers
- HMI modules
- Image and video
- JTAG accessories
- Keyboards, buttons
- LED drivers
- Memory card readers
- Memory modules
- Modules with power outputs
- Motor controllers
- Power modules
- RS485 converters
- RTC modules
- Servo Controllers
- TSOP infrared receivers
- USB Converters - I2C / 1-Wire / SPI
- Voltage converters
- Gadgets
- GPS
- Intelligent clothes
- LED - diodes, displays, stripes
- Luminous wires and accessories
- Memory cards and other data storages
- Passive elements
- PC accessories
- Printers
- Prototype boards
- Semiconductors
- A/C converters (ADC)
- Analog systems
- Audio systems
- Bridge rectifiers
- Button
- D/A Converters (DAC)
- DDS synthesizers
- Digital circuits
- Diodes
- Drivers of motors
- DSP microprocessors
- Energy counters
- Energy harvesting
- ESD security
- IGBT drivers and bridges
- Interface systems
- LED drivers
- Logic converters
- Memory
- Microcontrollers
- Optotriacs and optocouplers
- Other
- PLL generators
- Power systems
- Programmable systems
- Resetting systems
- RF systems
- RTC systems
- Sensors
- SoC systems
- Timery
- Touch sensors
- Transistors
- Sensors
- Accelerometers
- Air humidity sensors
- Air quality sensors
- Current sensors
- Distance sensors
- Flow sensors
- Gas sensors
- Gyroscopes
- Hall sensors
- Humidity sensors
- Infrared sensors
- Light and color sensors
- Liquid level sensors
- Magnetic sensors (compasses)
- Medical sensors
- Motion sensors
- PH sensors
- Position sensors
- Pressure sensors
- Pressure sensors
- Reflection sensors
- Sensors 6DOF/9DOF/10DOF
- Sensors of liquid quality
- Temperature sensors
- Vibration sensors
- Sound transducers
- Switches and buttons
- Cables
- INTERNET OF THINGS (IoT)
- MECHANICS
- POWER
- R/C MODELLING
- RASPBERRY PI
- Accessories for Raspberry Pi
- Audio video cables for Raspberry Pi
- Case Raspberry Pi
- Cooling for Raspberry Pi
- Displays for Raspberry Pi
- Extension modules for Raspberry Pi
- Memory cards for Raspberry Pi
- Power for Raspberry Pi
- Raspberry Pi 3 model A+
- Raspberry Pi 3 model B
- Raspberry Pi 3 model B+
- Raspberry Pi 4 model B
- Raspberry Pi 400
- Raspberry Pi 5
- Raspberry Pi cameras
- Raspberry Pi Compute Module
- Raspberry Pi model A/ B+/2
- Raspberry Pi Pico
- Raspberry Pi prototyping
- Raspberry Pi Zero
- Raspberry Pi Zero 2 W
- RETIRED PRODUCTS
- ROBOTICS
- SALE
- SOFTWARE
- STARTER KITS, PROGRAMMERS, MODULES
- Alchitry FPGA
- Altera FPGA
- Analog electronics
- Atmel SAM
- Atmel Xplain
- AVR
- Banana Pi
- BeagleBone
- chipKIT
- Coral
- CPLD Xilinx
- Cubieboard
- DFRobot FireBeetle
- Feather
- Freedom (Kinetis)
- FriendlyELEC
- HummingBoard
- Intelligent clothes
- Kit with a book
- LattePanda
- LPC (NXP)
- M5Stack
- Micro:bit
- Nvidia Jetson
- Odroid
- ODYSSEY
- Orange Pi
- Other development kits
- Peripheral modules
- PIC
- Raisonance
- Raspberry Pi RP2040
- RFID
- RISC-V
- SBC Embest
- SBC MYIR
- SBC others
- SBC UDOO
- Segger programmers
- SoMLabs
- Sparkfun MicroMod
- STM32
- STM32 Discovery
- STM32 MP1
- STM32 Nucleo boards
- STM8
- Teensy
- Universal programmers
- WRTNode
- Xilinx FPGAs
- WORKSHOP
- Adhesives and gluers
- Anti-static mats (ESD)
- Chemistry
- CNC milling machines
- Crimping tools
- Dispensing needles
- Drills
- Files
- Generators
- Handles, magnifiers
- Heat-shrink tubing
- Insulation strippers
- Keys
- Knives and scissors
- Laboratory power supplies
- Laminates
- Measuring devices
- Mikroskopy
- Mini drills and grindrers
- Organizers
- Oscilloscopes and accessories
- Pliers and pincers
- Power tools
- Riveting tools and rivets
- Screwdrivers
- SMD Accessories
- Soldering
- Tapes (aluminum, kapton, copper, insulating)
- Tweezers
- Ultrasonic cleaners
- Vices
- 3D PRINTING
New products
New products
zł179.42 tax excl.
Development kit with ESP32 module and LoRa communication. It is equipped with an integrated ESP32-C3 chip with a 32-bit RISC-V core processor and a Wio-E5 STM32WLE5JC module as a long-range controller that supports the LoRa protocol. Seeed Studio 114992985
Free shipping
free shipping in Poland for all orders over 500 PLN
Same day shipping
If your payment will be credited to our account by 11:00
14 days for return
Each consumer can return the purchased goods within 14 days
Description
Development kit with ESP32 module and LoRa communication. It features an integrated ESP32-C3 chip with a 32-bit RISC-V core processor that operates at up to 160MHz. It comes with 2.4GHz Wi-Fi communication and supports Station Mode, SoftAP Mode, SoftAP Mode. It runs in ultra-low power mode, also supporting Bluetooth 5 and Bluetooth Mesh. The chip has 400 kB of SRAM and 4 MB of Flash. The kit uses the Wio-E5 STM32WLE5JC module as a long-range controller that supports the LoRa protocol in the global frequency band with a transmission range of up to 10 km.
An important element of the set are two CAN interfaces. The CAN bus (Controller Area Network) is used to enable microcontrollers and devices to communicate with each other in networks used e.g. in vehicles, which allows for control and data collection. These devices are also called electronic control units (ECU) and enable communication between all parts of the vehicle. CAN is a serial communication bus designed for industrial and automotive applications.
The board provides a rich set of interfaces, including Grove connectors for connecting sensors and modules. It is designed according to industry standards with a wide operating temperature ranging from -40℃ to 85℃ and an output power of up to +20.8dBm at 3.3V.
Features
- ESP32-C3 SoC Processor, Single-core 32-bit RISC-V processor with up to 160MHz
- Communication WiFi 2.4 GHz, Bluetooth 5.0, Bluetooth Mesh
- Power supply: 5V/USB, Lipo battery 3.7V, DC input 7-28V
- Voltage output: 3.3V
- Output power: Up to 20.8 dBm at 3.3 V
- Frequency band: EU868/US915/AU915/AS923/KR920/IN865
- Protocol: LoRaWAN
- Sensitivity: 116.5dBm to -136dBm
- Modulation: LoRa, (G)FSK, (G)MSK, BPSK
- CAN 2.0: up to 1Mbps
- CAN-FD: up to 5Mbps
Kit contains
- Wi-E5 CAN Development Board
- EU868 antenna
- u.FL antenna
- Case
You might also like
Development kit based on ATSAMD51 with WiFi and BLE 5.0. It is equipped with a 2.4-inch LCD screen, IMU (LIS3DHTR), microphone, buzzer, microSD card slot, light sensor and infrared transmitter (IR 940nm). Seeed Studio 102991299
Power supply module with a 650 mAh battery for the Wio Terminal set. Seeed Studio 103990564
Other products in the same category (16)
Espressif ESP32-S3 WiFi and BLE chip module with 1.14" TFT LCD display. It integrates a LiPo charging circuit and an RGB diode. It is equipped with a STEMMA QT connector. Adafruit 5691
No product available!
Board with WiFi and Bluetooth Espressif ESP32-C3 module. It offers 4MB Flash and 400KB SRAM and a LiPo charging circuit. The set includes an expansion board with a display connector. DFRobot DFR0868
Development board with WiFi and Bluetooth module Espressif ESP32-WROVER. It is equipped with a microSD card slot, a USB-UART converter and a Li-Ion battery charging system. TTGO T8 V1.1 ESP32
Module from the ESP32 series, combining a powerful microcontroller, Wi-Fi and Bluetooth 4.2 BLE. ESP-WROVER-B has a built-in PCB antenna, a large number of GPIO lines and small dimensions. Adafruit 3979
No product available!
Adafruit HUZZAH32 is a development board with a built-in WiFi ESP32 module. Processor frequency: 240 MHz, the module has a built-in system for charging Li-Pol batteries. The plate has soldered goldpin connectors (female extension). Adafruit 3619
Module with WiFi Espressif ESP32-S2 WROOM. It integrates a set of peripheral devices - capacitive touch sensors, SPI, UART, I2S and I2C. SparkFun WRL-15663
Espressif ESP32-C3 WiFi module board with RISC-V core. It offers 4 MB Flash memory and 400 kB SRAM and an RGB LED. It has a built-in ceramic WiFi/BLE antenna. Waveshare ESP32-C3-Zero
No product available!
Development board with WiFi / Bluetooth Espressif ESP32-WROVER module. The board is equipped with numerous peripheral systems, eg SD card slot, audio codec, a series of LEDs controlled by one line and a 9-axis IMU system. TTGO TAudio V1.5 ESP32-WROVER
No product available!
Development board equipped with an ESP32 module and a 3.5-inch color touch screen. Seeed Studio 102991454
No product available!
Module with WiFi Espressif ESP32-S2. It integrates the TFT LCD display, SPI Flash memory, LiPo charging circuit and RGB diode. It is equipped with a STEMMA QT connector. Adafruit 5300
M5Stack series kit equipped with ESP32 and camera with OV2640 sensor. It has a built-in W5500 chip and can be powered by the RJ45 (PoE) connector. M5Stack U121
Module with WiFi and Bluetooth Espressif ESP32 WROOM. It integrates a set of peripherals - capacitive touch sensors, Hall sensors, SD card interface, Ethernet, SPI, UART, I2S and I2C. SparkFun WRL-20168
MicroMod main module with ESP32 chip. Equipped with an M.2 connector, it can work with MicroMod expansion boards. SprakFun WRL-16781
Espressif ESP32-C3 WiFi module board. It offers 4 MB of Flash memory and 400 kB of SRAM, as well as an RGB diode. It is equipped with a STEMMA QT connector. Adafruit 5700
Board with the WiFi Espressif ESP32-S2 module. Offers 4MB Flash and 8MB SRAM. Leads are compatible with HAT modules for Raspberry Pi Pico. Waveshare ESP32-S2-Pico
ESP32-S3 development board equipped with a 32-bit dual-core Xtensa 32-bit LX7 processor. It is equipped with a 1.14-inch IPS LCD display with a resolution of 240 x 135 pixels and a micro SD card slot. It has the format of a USB dongle with a type A connector, which makes it convenient and handy to use. Waveshare ESP32-S3-GEEK
No product available!