4-pin JST PH to JST SH Cable - STEMMA QT adapter for JST SH 100mm
search
  • 4-pin JST PH to JST SH Cable - STEMMA QT adapter for JST SH 100mm
  • 4-pin JST PH to JST SH Cable - STEMMA QT adapter for JST SH 100mm
ID: 1179400
5906623431243
zł5.90
Tax included

zł4.80 tax excl.

The JST PH to JST SH 200 mm cable enables quick and clean connection of STEMMA, STEMMA QT, and Qwiic modules in I2C-based projects. It's ideal for electronics prototyping, robotics, and education, especially where compatibility between different connector and voltage standards is required. Adafruit 4424

24h
Available
Available quantity: 46
STEMMA QT JST cable:
Arduino MKR Spring probes Alligator clip connectors Female goldpin Male goldpin Grove (100mm)
Grove (200mm)
Kamami is the official distributor of Adafruit modules and development kits. All boards of this brand in our offer are original and come directly from the manufacturer.

Description

This 200 mm long jumper cable is designed to connect modules and development boards equipped with 4-pin JST PH (2.0 mm) and JST SH (1.0 mm) connectors, known as STEMMA and STEMMA QT/Qwiic, respectively. This design enables direct I2C bus communication between compatible sensors, controllers, and hosts, without the need for soldering.

The JST PH connector features distinct latches for a stable connection in benchtop and prototyping applications, while the JST SH connector allows for dense component packing in compact designs. If necessary, the center key of the JST PH connector can be ground to fit Grove sockets.

This cable supports STEMMA, STEMMA QT, and Qwiic modules, enabling the connection of I2C sensors powered by 3-5 V to hosts operating at 3.3 V or 5 V, while maintaining voltage control on the power and signal lines.

Features

  • JST PH 4-pin connector, 2.0 mm pitch
  • JST SH 4-pin connector, 1.0 mm pitch (Qwiic / STEMMA QT)
  • Cable length: 200 mm
  • I2C bus support
  • Latching connectors for easy assembly and disassembly
  • Wire colors: black – GND, red – V+, blue – SDA, yellow – SCL
  • Compatible with 3.3 V and 3–5 V modules when the correct power supply configuration is maintained
1179400

Data sheet

Wtyk A
JST-SH 1,0 mm
Wtyk B
JST-PH 2,0 mm
Number of cores/wires
4
Cable length (cm)
20 cm

Manufacturer

  • BTC Korporacja sp. z o. o.
  • Ludwinowo Zegrzyńskie 52G
  • 05-140 Ludwinowo Zegrzyńskie
  • Poland
  • [email protected]
  • 22 767 36 20

Responsible person

  • BTC Korporacja sp. z o. o.
  • Ludwinowo Zegrzyńskie 52G
  • 05-140 Ludwinowo Zegrzyńskie
  • Poland
  • [email protected]
  • 22 767 36 20

You might also like

Other products in the same category (16)