

A set of 10 cables, 30 cm long, for analog sensors compatible with the Gravity standard. The cable is terminated on one side with a JST PH2.0-3P connector and on the other with a goldpin 2.54 mm connector. It allows to connect the Gravity modules to the control board, eg Ardunio.
Data sheet
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Arduino Uno Rev3 is a popular board with Atmel ATmega328 microcontroller from the AVR family, there are 14 I / O lines, 6 PWM channels and 6 analog inputs. The additional ATmega16U4 microcontroller realizes communication via the USB interface. Arduino A000066
Expansion board for Arduino, allows easy connection of XBee modules, has separate outputs for I2C, SPI and UART buses. The built-in 3.3V voltage stabilizer and operating mode switch make it easier to program the Arduino when the XBee module is connected to the sockets. DFRobot DFR0265
A set of 10 cables, 30 cm long, compliant with the Gravity standard. DFRobot FIT0513
Flexible 4-core cable, 500 mm long, terminated on both sides with a Qwiic plug. Sparkfun PRT-17257
No product available!
7-wire cable, 10 cm long, with a JST SH-1.0 female plug at one end
2-core cable, 20 cm long, with JST PH plug (2mm pitch). The ends of the wires are isolated and tinned
No product available!
No product available!
10-wire cable, 10 cm long, with a JST SH-1.0 female plug at both ends
Flexible 4-core cable, 50 mm long, terminated on both sides with a Qwiic plug. Sparkfun PRT-17260
No product available!
Female-female cable, 16 cm long, with JST-SH 6-pin plug on both sides. Suitable for micro DC motor encoders with gear. Pololu 4766
12-wire cable, 10 cm long, with a JST SH-1.0 female plug at both ends
4-core cable, 20 cm long, terminated on both sides with a Grove plug. Compatible with the interface used in Seeed Studio and M5Stack modules. Seeed Studio 110990027
6-pin female JST SH-type connector that works with Micro Metal Gearmotor Encoders. Pololu 4764
2-core cable, 20 cm long, with JST XH plug (2.50 mm pitch). The ends of the wires are isolated and tinned
9-wire cable, 10 cm long, with a JST SH-1.0 female plug at both ends
2-wire cable with JST plug, cable ends are tinned, length 15 cm, 2mm pitch. The cable has an additional 2-pole angled cable-to-board socket
No product available!
2-core connection cable, 15 cm long. Completed on one side with a 2x1 JST connector, and on the other with a 2mm pitch. CAB_E
Set of 10 cables, 30 cm long, for analog sensors compatible with the Gravity standard. DFRobot FIT0031