Yellow 16 LED Circular Light Board with Lead

Kitronik 2726 is a lilac LED designed for use in e-textiles, allowing for easy integration of lighting effects into textile projects. With a built-in resistor and clearly marked polarity (+ and -), the LED is simple to use and safe to incorporate with conductive materials.

Module with green LED diode and potentiometer. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104030007

Module with 7 RGB LEDs WS2812 type controlled by serial signal. It can be powered by 5V, only one signal line is required for control

A module for building a rear bicycle light using 1000 mCd red LEDs. Power supplied by AA batteries, which are not included in the kit. Kitronik 2106

Gravity module with a colored RGB WS2812 LED. Thanks to the controller built into the diode, you can connect the modules in series and control all with one microcontroller port. DFRobot DFR0605

Module with red LED, digitally controlled. Perfect for people starting to play with Arduino. Equipped with a Gravity interface. DFRobot DFR0031-R

The module is equipped with three RGB SK6812 LEDs. It is designed to work with the M5Stack sets. Communicates via a single-wire digital interface. M5Stack U003

Digitally controlled module with LED. Perfect for people starting their fun with Arduino. Equipped with an XH2.54 connector

Module with white LED diode and potentiometer. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104030009

Crowtail-LED Bar 2.0 is a compact data visualization module with 10 LED segments, intended for projects based on Arduino and the Crowtail system. It enables graphical representation of levels and values, and thanks to the cascading function it is suitable for more advanced indicators and light animations.

8-segment display module, 4 digits with commas

Gravity: Digital LED String Lights (Warm White) consist of a series of warm white LEDs. It is powered by a voltage of 2.5 ... 5 V and consists of 40 LEDs placed on a 4-meter cable. DFRobot DFR0448

RGB Panel Shield is an extension in the form of shield overlays designed for Arduino. With its help it is possible to control the RGB 32x32 LED display (refresh 1: 8). Communication with the display takes place via a 2x8 connector. SparkFun SPX-14721

The Mini LED 5V module is designed to fit into a 20mm diameter interior. It is designed to have power requirements that are within the power limits of a computer\'s USB port (5V and well below 100mA). Kitronik 35137

Kitronik 2712 is a red LED designed for use in e-textiles, allowing for easy integration of lighting effects into textile projects. With a built-in resistor and clearly marked polarity (+ and -), the LED is simple to use and safe to incorporate with conductive materials.

The Satellite Module 001 is an RGB LED module from macetech, containing ten 100 mA 5-chip wide-angle (140 degree) red, green, and blue LEDs. The module runs at 10 V, for a maximum power of 3 W, and it is connected in a common-anode configuration. Pololu 1243