DFRobot Gravity - Analog light intensity sensor for Arduino

Color sensor equipped with the OPT4048 sensor from Texas Instruments. It allows you to determine the characteristics of ambient light by measuring parameters such as light intensity, color in the CIE XY, LUV coordinate systems, as well as color temperature. The module is equipped with Qwiic connectors. SparkFun SEN-22639

Photodiode Brightness Sensor Module, RoHS

UV Sensor with response spectrum: 200nm-370nm

KAmodVL6180X is a module that allows to measure light intensity (ALS), distance to the object and recognition of gesture. It has an embedded voltage regulator and voltage level translators on signal lines. Thanks to this can be used in systems with 2.8...5.5V power supply voltage.

Module with color sensor TCS34725FN. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020341

Module with proximity and ambient light sensor based on the VCNL4020 system. It allows you to detect obstacles in the range from 0 to 20 cm and measure light intensity from 0.26 to 16,000 lux. It communicates via the I2C bus. Adafruit 5810

Great way to upgrade a project that uses a photocell and needs RoHS compliance. Due to the high rejection ratio of infrared radiation, the spectral response of the ambient light sensor is close to that of human eyes. Adafruit 2748

Module with 11-channel AS7341 sensor that allows to detect light in different wavelength ranges (color detection). It communicates via the I2C interface. DFRobot SEN0365

Module with an analog TEMT6000 light intensity sensor. The output voltage is linearly correlated with the intensity of the incident light. The module is supplied with the voltage from 3.3 to 5V

Module with a light intensity sensor BH1750FVI dedicated to the M5StickC sets. It communicates via the I2C interface. M5Stack U134

TSL25911FN light sensor module that can measure both visible and infrared light. It communicates via an I2C interface. Waveshare TSL25911 Light Sensor

Light sensor module in the form of a photoresistor. A comparator and a potentiometer are placed on the board. The module has a digital output

Sensor for detecting the distance, intensity and frequency of lightning within a radius of 40 km. The module enables weather enthusiasts to measure local storm data. SparkFun SEN-15441

Module with TCS3200D system - sensor of RGB light components

Module with an analog TEMT6000 light intensity sensor. The output voltage increases with increasing intensity of the incident light. The sensor is powered by 5 V. SparkFun BOB-08688

A module with a light sensor in the form of a photoresistor. There is a comparator and a potentiometer on the board. The module has a digital output