Bluetooth 3.0+EDR audio receiver with microphone + 3.5mm Jack adapter

MP3 panel for installation in the audio device. It allows you to play files in MP3 format from a USB memory or a microSD card. It has a built-in 3.5mm Jack connector with an audio output

MP3 panel with LCD display for installation in the audio device. It allows you to play files in MP3, WAV and WMA format from USB memory, SD card, via AUX and Bluetooth 5.0. Has a built-in FM receiver. modBluAud

Mini MP3 player with 128 MB built-in memory. It can work as a separate device and play sounds or be controlled via the UART serial interface. DFRobot DFR0768

Adafruit 2217

Module with a multi-channel WAV player. It allows you to mix 32 mono or 18 stereo tracks with the ability to connect to any MIDI controller. It has 8 mono or 4 stereo audio outputs. SparkFun WIG-18159

Audio receiver with Bluetooth 4.2 module. It is powered by a microUSB connector or a battery and is equipped with a charging circuit

Mini MP3 player with microSD card support. It can work as a separate device and play sounds from the card or be controlled via the UART serial interface. DFRobot DFR0299

Audio player with HiFi amplifier in aluminum housing. It allows you to play files from USB memory, SD card, via the audio connector and Bluetooth. It has a built-in FM receiver

Audio module based on a 32-bit PCM5102A DAC converter intended for cooperation, among others with Raspberry Pi minicomputers. Communication via the I2S interface. GY-PCM5102

Audio module with DAC, headphone amplifier and display, designed to work with the Raspberry Pi. It is based on the PCM5100A system and communicates via the I2S interface. Pimoroni PIM482

This breakout board, the ultimate companion for the VLSI VS1053B DSP codec chip, can decode a wide variety of audio formats MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC, WAV (PCM and ADPCM); it can be used to record audio in both PCM (WAV) and compressed Ogg Vorbis. 8 GPIO pins can be used for lighting up small LEDs or reading buttons. Adafruit 1381

An audio module with a DAC converter designed to work with the Raspberry Pi. Supports I2S/DSD/Coaxial input, Analog/Coaxial/Optical/I2S output, and has 384K/32Bit decoding function. DFRobot DFR0941

WM8960 stereo codec module with driver for 1W class D speakers and headphones. It uses the I2S interface and the I2C bus to configure the system. SparkFun BOB-21250

Gravity: UART MP3 Voice Module is an MP3 sound player module with a built-in 8 MB memory. It is powered by 3.3-5V and controlled by the UART interface. DFRobot DFR0534

Qwiic Tsunami Super WAV Trigger - a module with a multi-channel WAV player

This Bluetooth Audio receiver module includes a USB port and TF card slot. With a pre-amp output, you can drive headphones or a 3W speaker directly. You can also add an active power amplifier and connect a loudspeaker. The module supports MP3, WMA, WAV and lossless FLAC audio formats. DFRobot TEL0108