OM-SE050ARD - EdgeLock SE050 expansion board for Arduino

RGB Panel Shield is an extension in the form of shield overlays designed for Arduino. With its help it is possible to control the RGB 32x32 LED display (refresh 1: 8). Communication with the display takes place via a 2x8 connector. SparkFun SPX-14721

e-Paper display controller module with a standard Arduino connector. It has a built-in MX25R6435F Flash memory with a capacity of 8 MB and a 24-pin FFC connector dedicated to e-Paper displays. Waveshare e-Paper Shield (B)

WiFiBee-MT7681 is an XBee module based on the MT7681 Wi-Fi module. WiFiBee supports standard IEEE802.11b / g / ni protocols. Can be used as a remote programmer for Arduino tiles. It is powered by 3.3 V. DFRobot TEL0107

(DFR0144) Relay Shield for Arduino V2.1

Arduino Multifunctional Shield; LED, 7seg, buzzer, switch

This LC8822-2020 module with eight addressable RGB LEDs allows you to create lighting effects, animations, and visual signals in electronics projects. Thanks to I2C/Qwiic communication and an STM32C011 microcontroller, integration with the Arduino UNO R4 WiFi or Nano is quick and easy, and the I2C address can be easily changed programmatically. The module is fully compatible with the Arduino Cloud and the Modulino library, allowing you to launch your first effects in minutes. Arduino ABX00109

Gravity: IO Expansion & Motor Driver Shield is an Arduino compatible expansion board that provides digital I / O ports, analog I2C, SPI and UART interfaces, as well as a DC motor driver. DFRobot DFR0502

This module with three buttons and three LEDs provides easy control and visualization for electronics projects. Thanks to I2C/Qwiic communication and an STM32C011 microcontroller, the module integrates quickly with the Arduino UNO R4 WiFi and Nano, while the programmable I2C address allows for combining multiple modules in a single system. Its compact and robust design makes Buttons ideal for education, prototyping, IoT systems, and complex interactive projects. Arduino ABX00110

The module with connectors is dedicated to the Arduino Portenta boards. It helps in prototyping and testing connections. Arduino ASX00031

Cytron SHIELD-ROBO-UNO is a complete Arduino shield integrating DC motor control, servo ports, Grove/QWIIC/Stemma QT connectors, and a built-in LiPo/Li-Ion battery charging circuit. It enables rapid prototyping of robots and IoT projects, eliminating the need for complex wiring and multiple separate modules.

DEV-14352

GPS expansion module with 72-channel GNSS receiver SAM-M8Q dedicated to Arduino. The chip can receive data from all major positioning systems: GPS, GLONASS and Galileo. It has derived UART and I2C interfaces. Arduino ASX00017

Cap for Xbee and Arduino. It has been designed for wireless sensor networks such as WiFi, Bluetooth 2.0 / 4.0 and Zigbee. DFRobot DFR0015

Shield dedicated to Arduino boards, which allows you to program AVR systems. Equipped with ISP connectors (6-pin and 10-pin) and a ZIF-28 base. AVR ISP Shield

This shield allows you to interface Wixel wireless modules to your Arduino (and other compatible products), enabling simple wireless programming, debugging, and control using standard Arduino software. Pololu 2513

A module with a microSD card slot for Arduino. Equipped with two Grove connectors with I2C and UART for connecting additional sensors. Seeed Studio 103030005