Bees Shield For Arduino with 2 xBee slots

Gravity: Heart Rate Monitor Sensor is a sensor used to measure heart activity. Adapted for easy use with Arduino. SparkFun SEN0213

Shield with a 6-pin JST SH connector dedicated to Arduino Mini. It allows you to connect the GPS module with the GP-735 chip. SparkFun GPS-14030

WiFiBee-MT7681 is an XBee module based on the MT7681 Wi-Fi module. WiFiBee supports standard IEEE802.11b / g / ni protocols. Can be used as a remote programmer for Arduino tiles. It is powered by 3.3 V. DFRobot TEL0107

The overlay allows for easier connection of wires to the Arduino UNO R3 board. Thanks to the screw connections, it is possible to fast and securely fix the cable, and the built-in female connectors allow the application of additional Arduino shields. Screw shield

The overlay solves the problem of limitations in the use of multiple overlays compatible with Arduino UNO R3. The board allows you to connect different shields without their mutual influence on each other (eg without conflict on the UART bus or GPIO lines). Extension dedicated for Arduino Mega and ADK devices. DFRobot DFR0256

Nano I / O Shield for Arduino Nano is an expansion board for Arduino Nano that provides digital, analog pins, power inputs and a connector for the Bluetooth module. DFRobot DFR0012

The Beetle shield is designed to attach a Beetle controller for easy connecting servos and sensors. DFR0285

Module with LCD display dedicated to Arduino boards. Equipped with a joystick and Gravity connectors. DFRobot DFR0287

Base Shield V2 is an extension for tiles with an Arduino shield connector, it has a Grove connector, which can be connected to Grove-compatible modules / sensors. Seeedstudio 103030000

DEV-14352

4inch Touch LCD Shield for Arduino is an overlay with a 4-inch LCD display. The screen has a resolution of 480x320 pixels. Communication with the display is via the SPI interface. Waveshare 4inch TFT Touch Shield

Gravity: IO Expansion & Motor Driver Shield is an Arduino compatible expansion board that provides digital I / O ports, analog I2C, SPI and UART interfaces, as well as a DC motor driver. DFRobot DFR0502

RGB Panel Shield is an extension in the form of shield overlays designed for Arduino. With its help it is possible to control the RGB 32x32 LED display (refresh 1: 8). Communication with the display takes place via a 2x8 connector. SparkFun SPX-14721

A development kit containing the A71CH Plug & Trust module, enabling easy and fast creation of secure IoT applications. NXP OM3710 / A71CHARD

Voltage divider module for measuring quantities in the 0V to 25V range.

Cap for Xbee and Arduino. It has been designed for wireless sensor networks such as WiFi, Bluetooth 2.0 / 4.0 and Zigbee. DFRobot DFR0015