Bluno Beetle Shield

Multifunctional expander (shield) for NUCLEO and Arduino equipped with Bluetooth 2.0+EDR (HC-05) interface, MEMS 3DoF LIS35, LED-RGB, joystick and analog STLM20 temperature sensor developed and produced by KAMAMI.

LED matrix display module (in blue color) with an organization of 14 columns x 9 lines, compatible with Arduino.

The overlay solves the problem of limitations in the use of multiple overlays compatible with Arduino UNO R3. The board allows you to connect different shields without their mutual influence on each other (eg without conflict on the UART bus or GPIO lines). Extension dedicated for Arduino Mega and ADK devices. DFRobot DFR0256

I/O pin expander designed for Arduino platforms. Provides 48 connections to increase the number of analog inputs, digital inputs and digital outputs. SparkFun DEV-11723

WiFiBee-MT7681 is an XBee module based on the MT7681 Wi-Fi module. WiFiBee supports standard IEEE802.11b / g / ni protocols. Can be used as a remote programmer for Arduino tiles. It is powered by 3.3 V. DFRobot TEL0107

GPS expansion module with 72-channel GNSS receiver SAM-M8Q dedicated to Arduino. The chip can receive data from all major positioning systems: GPS, GLONASS and Galileo. It has derived UART and I2C interfaces. Arduino ASX00017

Controller module dedicated to Arduino boards. Equipped with 4 buttons, a two-axis joystick and an Xbee connector. DFRobot DFR0008

This module with three buttons and three LEDs provides easy control and visualization for electronics projects. Thanks to I2C/Qwiic communication and an STM32C011 microcontroller, the module integrates quickly with the Arduino UNO R4 WiFi and Nano, while the programmable I2C address allows for combining multiple modules in a single system. Its compact and robust design makes Buttons ideal for education, prototyping, IoT systems, and complex interactive projects. Arduino ABX00110

Base Shield V2 is an extension for tiles with an Arduino shield connector, it has a Grove connector, which can be connected to Grove-compatible modules / sensors. Seeedstudio 103030000

The X-NUCLEO-53L0A1 expansion board features the VL53L0X ranging and gesture detection sensor, based on ST’s FlightSense™, Time-of-Flight technology. It is an evaluation board that provides an introduction to the ranging and gesture detection capabilities of the VL53L0X module

(DFR0105) Power Shield (Arduino Compatible)

Cap for Xbee and Arduino. It has been designed for wireless sensor networks such as WiFi, Bluetooth 2.0 / 4.0 and Zigbee. DFRobot DFR0015

The overlay allows for easier connection of wires to the Arduino UNO R3 board. Thanks to the screw connections, it is possible to fast and securely fix the cable, and the built-in female connectors allow the application of additional Arduino shields. Screw shield

Shield - Xbee w / o RF module

Gravity: IO Expansion & Motor Driver Shield is an Arduino compatible expansion board that provides digital I / O ports, analog I2C, SPI and UART interfaces, as well as a DC motor driver. DFRobot DFR0502

This LC8822-2020 module with eight addressable RGB LEDs allows you to create lighting effects, animations, and visual signals in electronics projects. Thanks to I2C/Qwiic communication and an STM32C011 microcontroller, integration with the Arduino UNO R4 WiFi or Nano is quick and easy, and the I2C address can be easily changed programmatically. The module is fully compatible with the Arduino Cloud and the Modulino library, allowing you to launch your first effects in minutes. Arduino ABX00109