Scale module with load cell up to 2kg

SEN-08685

Force-Sensing Resistor - 1.5" Square

Aluminum extensometer beam, allowing measurement of weight up to 20 kilograms. It has four wires. It is used in kitchen scales and portable scales, it has a 21 cm cable, RoHS.

Module with a deflection sensor with two measuring probes. The board houses the ADS1015 converter, which is an ADC converter with an output in the form of an I2C interface. SparkFun SEN-14666

The module allows you to attach a strain gauge (working in the Wheatstone bridge circuit) and convert the analog signal into its digital representation, available on the module output lines. The system processes the signal with a 24-bit resolution and can be powered by 2.7V - 5.5V. The module is especially recommended for constructing digital scales in combination with Arduino

The SparkFun Load Sensor Combinator is a bare PCB that combines four load sensors into a standard four-wire Wheatstone bridge configuration. BOB-13878

Aluminum extensometer beam, allowing measurement of weight up to 1 kilogram. It has four wires. It is used in kitchen scales and portable scales.

Set with the ADC HX711 transducer module and a pressure sensor in the form of a tensometric beam. It communicates via the UART interface. It allows you to build a simple home scale. DFRobot SEN0160

Grove module with FSR402 pressure sensor. The board is equipped with a Grove connector with an analog output. Seeed Studio 101020553

Round, flexible, pressure sensor that can be used to implement very sensitive force detection. The sensor is durable and designed to detect static and dynamic pressure at high response speeds. DFRobot SEN0297

Flexible pressure sensor with dimensions of 400x15 mm. Designed to detect static and dynamic pressure at high reaction speed. DFRobot SEN0299

A round, flexible, pressure sensor that can be used to realize very sensitive force detection. The sensor is durable and designed to detect static and dynamic pressure at high reaction speed. DFRobot SEN0298

Simple-to-use, open source solution for measuring weight and temperature with the ability to read multiple types of load cells and offers a simple-to-use serial menu to configure calibration value, sample rate, time stamp and units of precision. SEN-13261

This disc load cell (sometimes called a strain gauge) can translate up to a whopping 200kg of pressure (force) into an electrical signal. Each load cell is able to measure the electrical resistance that changes in response to, and proportional of, the strain (e.g. pressure or force) applied to the disc. SEN-13332

SEN-11207 - Flexiforce Pressure Sensor - 25lbs (1" area)