- Out-of-Stock

1.75 mm PLA filament for 3D printing by ROSA3D. 1 kg of filament is wound on the spool. The recommended printing temperature is in the range from 185°C to 225°C, and the bed temperature during printing in the range of 40°C - 60°C, however, when using adhesives, heating the bed is not necessary.
The filament was placed on a cardboard coil manufactured using only certified bio-friendly eco-friendly adhesives. The shape of the coil is stable and guarantees satisfaction. In order to use the filament, it is necessary to print two reusable discs, which must be pressed into the refill thimble.
Rosa3D is a Polish manufacturer of filaments intended for both hobby and industrial printing. Thanks to many years of experience and modern machinery, the company is able to provide good quality and accuracy of the diameter and roundness of the filament. Filament PLA Starter from Rosa3D was designed for beginner users of 3D printers. The simplicity of PLA Starter printing will allow you to enjoy aesthetic prints, and over time will convince you to print more and more complex and demanding projects.
PLA is the basic material used in 3D printing. PLA Starter is characterized by low shrinkage and no unpleasant odor. The prints are characterized by excellent layer adhesion and very good detail reproduction. The filament is made of a biodegradable biopolymer. It was made of ingredients approved for contact with food.
No product available!
No product available!
No product available!
No product available!
The BBC micro:bit is a pocket-sized computer 16MHz, 32-bit ARM Cortex-M0 microcontroller with 256KB Flash, 16KB RAM that lets you get creative with digital technology. DEV-14208
No product available!
No product available!
Module with a digital gas sensor MiCS-4514. It allows you to measure the concentration of CO, C2H5OH, H2, NO2, NH3 and communicates via the I2C interface. DFRobot SEN0377
No product available!
No product available!
No product available!
The SAM4L Xplained Pro starter kit is ideal for evaluation and prototyping with the SAM4L Cortex™-M4 processor-based microcontroller. The ATSAM4L-XSTK starter kit includes the Atmel I/O1 Xplained Pro, OLED1 Xplained Pro, PROTO1 Xplained Pro, and SLCD1 Xplained Pro extension boards.
No product available!
No product available!
HK MultiWii 328P Flight Controller w/FTDI & DSM2 Port (27033)
No product available!
No product available!
Assembled two-channel remote control receiver. AVT5455 / 2 C
No product available!
No product available!
A highly cost-effective audio hat which fits on the GPIO of the Raspberry Pi B+/2B/3B, uses i2S interface audio solution, supports 24-bit /192KHz high quality sound, compatible with other audio equipment via RCA lotus socket, includes a built-in high fidelity headphone amplifier, where you can plug in a 3.5mm audio jack directly. DFR0449
No product available!
Filament from ROSA3D made of high-quality PLA pellets. Placed on a cardboard thimble, on which 1 kg of 1.75 mm diameter filament is wound. ROSA3D ReFill PLA Starter Grey