- Out-of-Stock
New products
New products New products
Available
zł73.14
24h
Available
zł1,049.01
24h
Available
Electrodeposition
ID: 177755
Jack W. Dini
Electrodeposition allows the "tailoring" of the surface of the material, in the case of electroforming, the entire part. Deposits can be produced to meet a variety of designer demands. For the sake of the matter, and for the sake of the utmost importance. This book provides that understanding.
Introduction
Hydrogen Embrittlement
adhesion
Diffusion
Properties
Structure
Additives
porosity
stress
Corrosion
Wear
index
Introduction
Hydrogen Embrittlement
adhesion
Diffusion
Properties
Structure
Additives
porosity
stress
Corrosion
Wear
index
177755
Other products in the same category (16)
No product available!
Starter kit with STM8S003K3T6 microcontroller (8 kB Flash), with built-in ST-Link programmer-debugger
Retired
No product available!
32-bit ARM Cortex-M0 MCU, 128 kB Flash, 8 kB SRAM, LQFP64, RoHS
Delivery date unknown
No product available!
16/32-bit ARM microcontrollers; 8 kB cache, up to 1 MB flash, Hi-Speed USB 2.0 device, SDRAM memory interface, NXP, TFBGA180, RoHS
Retired
No product available!
No product available!
No product available!
SIRCULAR AND I2C SYSTEM TESTER - PRINTED PLATES AND PROGRAMMED LAYOUT
Delivery date unknown
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
Spring dedicated to the heating table of 3D printers. It allows you to adjust the degree of tightening the knob, and thus enables the proper leveling of the working table
Retired
No product available!
An extension module to support two cameras designed for Raspberry Pi minicomputers. The board allows you to connect two cameras via CSI connectors to one connector of the minicomputer. ArduCAM B0195
Retired
No product available!
Jack W. Dini