- Out-of-Stock
Jerzy Szabatin
About the book
The first volume contains tasks illustrating, among others the following sections: linear and non-linear circuits of direct current, circuits of sinusoidal alternating current, periodic current, low-signal analysis as well as resonance circuits and network methods. The second volume includes the following sections: transients, crossovers, linear transmission systems and long lines as well as linear graphs and flow graphs, state variables method, binary synthesis and discrete systems.
Table of Contents
Part I
Preface
1. Basic concepts, elements and laws of circuit theory
2. DC linear circuits
3. Non-linear DC circuits
4. Circuits of sinusoidal alternating current
5. Periodic current circuits
6. Resonant circuits
7. Low signal analysis
8. Network methods
Appendix A. Fourier series
Literature
Part II
9. Transient states
9.1. Classic method
9.2. Operator method
10. Fours
11. Linear transmission systems
12. Line graphs and flow graphs
13. The method of state variables
14. Synthesis of bifidos
15. Long lines
16. Discrete systems
Appendix B. Laplace transformers
Appendix C. Fourier transformers
Appendix D. Designs from the four-part theory
Appendix E. Topological formulas
Appendix F. Formulas from the theory of long lines
Appendix G. Z-transformers
Literature
10.1" LCD IPS display. The display is equipped with a mini HDMI interface for image display and USB for power supply. Resolution 800x1280 pixels. DFRobot DFR0615
No product available!
Module with 4 relays JZC-11F with a load of 5A. It enables switching devices with high power using a microcontroller. I2C communication. SparkFun COM-16566
No product available!
Evaluation kit with SiFive Freedom E310 microcontroller with RISC-V (ISA) architecture. It includes 32MB QSPI flash memory, NXP K22 ARM Cortex-M4 microcontroller for USB support and JTAG interface, Qwiic and USB Type-C connector. SparkFun DEV-15594
No product available!
Cable with a length of 150 mm, on one side terminated with a Qwiic connector, and on the other side with single female goldpin connectors. It allows you to connect Qwiic modules, e.g. with development board. SparkFun CAB-14988
No product available!
Extension module for Raspberry Pi designed to build the user interface. It is equipped with a 2.4-inch TFT LCD display, microphones, speaker, buttons, joystick and RGB LEDs. SparkFun DEV-16653
No product available!
Adapter board from SODIMM200-2.5 to 2.54mm connectors
No product available!
Evaluation kit with Bluetooth 5.0 Sparkfun Artemis module. Equipped with a microphone, kmaers and accelerometer. Himax HM01B0 camera included. SparkFun KIT-17071
No product available!
The expansion module to support two cameras is designed for Raspberry Pi minicomputers. The board allows you to connect two cameras via CSI connectors to one minicomputer connector. ArduCAM B016601
No product available!
Evaluation kit with LittleBee GW1NR9 FPGA. It offers 8640 LUTs, 6480 Flip-Flops (FF), and has a built-in 8MB (64Mb) SDRAM. The board has 8 MB Flash, FTDI for UART, 8 LEDs and a button. TEC0117-01
No product available!
Evaluation kit with LittleBee GW1N-1 FPGA chip. Offers 1152 LUTs and 864 Flip-Flops (FF). The board has an FPC connector for the display and a USB type C. Sipeed Lichee Tang Nano
No product available!
Video splitter for connecting one input device to 2 receivers. Maximum 4K resolution supported. Lanberg SPV-HDMI-0002
No product available!
Video splitter for connecting one input device to 4 receivers. Maximum 4K resolution supported. Lanberg SPV-HDMI-0004
No product available!
Video splitter for connecting one input device to 8 receivers. Maximum 4K resolution supported. Lanberg SPV-HDMI-0008
No product available!
Video switch that allows you to connect 5 input devices to one HDMI receiver. The input signal can be selected using a button on the casing or the included remote control. Lanberg SWV-HDMI-0005
No product available!
A set of 8 knives, including 4 knives with broken blades and 4 special-purpose knives. Vorel 76280
No product available!
Module with an analog temperature and humidity sensor based on the SHT10 system. It is characterized by high reliability and stability with low energy consumption. It is compatible with 3.3V and 5V controllers. DFRobot DFR0066
No product available!
Jerzy Szabatin