AVT5094 F

Module with Xilinx Artix-7 100T system, 32MB FLASH memory and 8MB HyperRAM memory. TE0725-03-100-2C

Module with Xilinx Artix-7 100T system and 32MB FLASH memory. TE0725LP-01-100-2C

Module with Xilinx Artix-7 100T system and 32MB FLASH memory. TE0725LP-01-100-2D

Module with Xilinx Artix-7 100T system and 32MB FLASH memory. TE0725LP-01-100-2L

Base plate designed to work with TE0808 and TE0803 modules. It allows you to connect the module to external connectors and interfaces. TEBT0808-01

Base plate designed to work with TE0745 modules. TEB0745-02

Base plate for Trenz Electronics 4x5 cm modules, e.g. TE0741, TE0712. The board allows connecting to the module interfaces: USB, Ethernet, JTAG. TE0705-04

Base plate for Trenz Electronic 4 x 5 cm modules. It allows you to connect an FPGA system through board-to-board connections to external peripherals to test and develop software. TE0701-06

UltraITX + base board designed to work with TE0808 UltraSOM + MPSoC modules. It allows you to connect the module to external connectors and interfaces. TEBF0808-04

TEBA0841 is a base plate for Trenz Electronic 4 x 5 modules, e.g. TE0741 series. The FPGA input / output ports can be connected directly to the periphery via two 50 pin goldpin connectors. TEBA0841-01

TE0706 is a base plate for Trenz Electronic 4x5cm Muduors. It allows you to connect USB, JTAG and Ethernet interfaces. TE0706-02

Base plate for Trenz Electronics modules 4 x 5 cm, eg for TE0741. The board allows connecting to the module interfaces: USB, Ethernet, JTAG, UART. TE0703-05

USB TO UART solution with USB Type A connector, Waveshare

Oyvind Nydal Dahl

The second version of the clock synchronization signal receiver, transmitted with AM modulation (DCF77). The built-in MAS6180 system allows you to receive timing frames from a time pattern using a carrier frequency of 77.5 kHz. Thanks to this module, it is possible to create a clock with automatic date and time synchronization. The module has a ferrite antenna. modDCF77 v2

Pyboard is a compact development board that allows you to use the MicroPhyton software. Min. 3-axis accelerometer (MMA7670), diodes, monostable buttons and microSD memory card slot. Adafruit 3497