- Out-of-Stock

3-CHANNEL REMOTE CONTROLLER - PLATES AND PROGRAMMED SYSTEM
Professional remote control devices are very expensive, often beyond the reach of the average RC modeler. We offer hand-made workmanship, devices that are perfect for simple wheel and floating models. The components necessary to make it are easy to obtain and the transceiver path does not require tuning. The software can work in four modes: with three independent outputs (for servos), with the added V-tail mixer, with one output to the servo and two working in PWM mode and with one servo output, one working in PWM mode and one informing about direction (mode specifically for car models).
The device is especially recommended for RC modelers
Selected parameters:
Download
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
No product available!
No product available!
No product available!
Male terminal block, angled, 7-pin. Pitch 5.0mm. Height 7.8mm. 2EDGRC-5.0-7P
No product available!
No product available!
No product available!
Neodymium rectangular magnet with dimensions of 12x4mm a and a height of 4 mm.
No product available!
No product available!
No product available!
ARM7TDMI, 256kB Flash (ISP), 64kB RAM, 1xUSB Device, 3xUART USART DBGU, ADC, LQFP64
No product available!
The X-NUCLEO-NFC05A1 is an NFC card reader expansion board based on the ST25R3911B. The expansion board is configured to support ISO14443A/B, ISO15693, FeliCa™ and AP2P communication
No product available!
No product available!
No product available!
No product available!
No product available!
Roman Maniewski, Adam Liebert
No product available!
3-CHANNEL REMOTE CONTROLLER - PLATES AND PROGRAMMED SYSTEM