- Out-of-Stock
K4001 - mono power amplifier 7w
ID: 192552
Power amplifier mono 7w - set for self-assembly
Description
In this small amplifier, integrated circuit TDA2003 was used, supplying 4W rms for 4 obciąż load. The system is fully thermally and short-circuit protected. It can be powered from an ordinary DC power supply.
properties
- Musical power output 7 W / 4?
- Effective output power 3.5 W / 4? and 2W / 8?
- Total harmonics content 0.05% (1W / 1kHz)
- Frequency range: 20Hz ... 20kHz (-3dB)
- Signal to noise ratio 86 dB (weighted A)
- Input sensitivity 40 mV / 150 kOhm
- Protection against overdriving and short circuit
- 15 V DC / 0.5 A power supply
- Dimensions of the 55 x 35mm tile
192552
Manufacturer transfer multisort elektronik sp. z o.o Ustronna 41 93-350 Łódź Poland dso@tme.pl
Responsible person transfer multisort elektronik sp. z o.o Ustronna 41 93-350 Łódź Poland dso@tme.pl
Other products in the same category (16)
The module is used to build prototypes and designs based on the popular ATmega8 microcontroller. It is possible to mount another microcontroller from the AVR family, if only pin outs coincide with ATmega8. MOD-01.Z
Retired
No product available!
No product available!
Module with a relay with a permissible maximum current of 10A with a 5V coil (MOD-03.Z). The module has a transistor relay control transistor and an overvoltage / self-inductive diode from the coil.
Retired
No product available!
The converter enables simple connection of the project being built with the UART output to the computer via a USB interface. After connecting to a computer, a virtual COM port is created. MOD-05 / AZ
Retired
No product available!
No product available!
The stabilizer module is used to stabilize the output voltage at an appropriate level and filter interference. The module can be supplied with voltage up to + 16V, and the output voltage is + 3.3V. MOD-06 / 3V3.Z
Retired
No product available!
The stabilizer module is used to stabilize the output voltage at an appropriate level and filter interference. The module can be supplied with voltage up to + 16V, and the output voltage is + 5V. MOD-06 / 5V.Z
Retired
No product available!
The stabilizer module is used to stabilize the output voltage at an appropriate level and filter interference. The module can be supplied with voltage up to + 16V, and the output voltage is + 9V. MOD-06 / 9V.Z
Retired
No product available!
The stabilizer module is used to stabilize the output voltage at an appropriate level and filter interference. The module can be supplied with voltage up to + 16V, and the output voltage is + 12V.
Retired
No product available!
No product available!
No product available!
MT SPEC01 / 2015 RASPBERRY, ISSN 0462-9760
Delivery date unknown
No product available!
Dustyn Roberts
Delivery date unknown
No product available!
Atmel SMART SAM V71 Xplained Ultra development kit with ATSAMV71Q21 microcontroller with ARM Cortex-M7 core. ATSAMV71-XULT
Retired
No product available!
No product available!
No product available!
Power amplifier mono 7w - set for self-assembly