AVT1389 B

The board with the RP2040 microcontroller equipped with two ARM Cortex-M0 + cores operating at a frequency of 133 MHz, 264 kB RAM. There is as much as 16 MB of QSPI flash memory on the board. The system can be programmed in C / C ++ or microPython. KApico RP2040

Air quality sensor module based on the SGP40 system. It uses CMOSens® technology by Sensirion and provides information on air quality. Waveshare SGP40 VOC Sensor

5G/4G/3G and GNSS module with SIM8200EA-M2 chip. It allows you to make phone calls, SMS support, cloud communication and has support for GPS, Galileo, BeiDou, Glonass and QZSS. Waveshare SIM8200EA-M2 5G for Jetson Nano (EU)

Module with e-Paper display, 2.7" diagonal and 264x176 px resolution. Communication via SPI interface. Waveshare Pico-ePaper-2.7

A set for building a minicomputer based on Raspberry Pi CM4. It consists of a metal case with a fan, a power supply and a Mini Base Board (B) and a USB HDMI to FCC adapter. Waveshare CM4-IO-BASE-Acce D

The Uni-T non-contact thermometer is designed to measure the temperature of the human body. It allows you to measure the temperature in a non-invasive way in the range from 32°C to 42.9°C from a distance of 5 to 10 cm. Uni-T UT300H

Kit with 16 modules and the IO Expansion Shield designed to work with the Arduino Uno. Dedicated to learning programming and electronics

Development kit with ESP32 WiFi and Bluetooth module and 1.54 "ePaper display. Built-in IMU MPU6050 sensor and USB-UART converter. LilyGO TTGO T-Block ESP32

Module with a pulse sensor and the level of SpO2 (oxygen saturation level). It is based on the MAX30102 chip, dedicated to the T-Wristband

Programmable watch with ESP32-Pico-D4. Equipped with a touch button display, motion sensor, power management system, RTC clock and Lithium battery. LILYGO TTGO T-Wristband

Wrist strap for LilyGo TTGO t-wristband module. Black colour

Solar panel with an output voltage of 6 V and a power of 1 W. Provides high efficiency and work stability

8 Mpx camera module with IMX219 sensor and wide-angle lens. To be used as a replacement on the RPI Camera Board V2. ArduCAM B0194

Camera module designed for RP2040 development boards. It uses the Himax HM01B0 sensor to achieve excellent performance in low light. ArduCAM B328

The module with the OV5647 sensor, working with all versions of the Raspberry Pi. It uses a built-in movable IR-CUT filter that is turned on and off automatically depending on the lighting conditions. ArduCAM B003507

Set of 4 mounting plates for Raspberry Pi 4B compatible with 19-inch 3U rack mount. The holder shown in the 3rd picture is not included in the set and must be purchased separately. ArduCAM U6131