- Out-of-Stock
INTELLIGENT CAR INTERIOR LIGHT CONTROL - PRINTED PLATES AND PROGRAMMED SYSTEM
The driver of the vehicle cabin lighting lamp extends the time of its lighting when the door is closed. This allows you to conveniently insert the key into the ignition and fasten the seat belts. The lamp illuminates for about half a minute and then it is gradually turned off. However, if the ignition is switched on in the meantime, the interior lighting is switched off immediately.
The controller has additional functions. When you open the door, the light in the cabin turns on smoothly. The light is also switched on after switching off the engine (switching off the ignition switch) as long as the parking lights have been switched on. The device is equipped with the function of protecting the battery against discharging. If the vehicle door remains open, the interior lamp is extinguished after approx. 2.5 minutes. The control LED (flashing at a frequency of about 1 Hz), in addition to signaling the correct operation of the device can simulate the operation of the alarm.
The device is especially recommended for owners of older car models as well as those electronic engineers who want to explore the secrets of PWM steering
Selected parameters of the controller:
Download
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
The eMMC 5.1 flash memory module for Hardkernel Odroid XU4 computers. 128GB capacity, installed Linux operating system. The set includes a microSD adapter. Hardkernel
No product available!
Switch mode power supply with 12V output voltage and 1A current. It has a DC 5.5x2.1 plug and an EU plug. The power supply has built-in overload, overvoltage and short-circuit protection. ESPE-1212-W2E
No product available!
Rasberry Pi compatible FPGA module integrating Xilinx Zynq-7010, 512 MB DDR3L SDRAM, 4 USB ports, Ethernet port and 16 MB Flash memory. Trenz Electronic TE0726
No product available!
Li-Po battery 3.7V / 320mAh, PCM safety, connector + JST-BEC 2,54 socket, 2 pins, cable length 150mm
No product available!
Expansion module for NanoPi Duo2, equipped with an Ethernet port, serial port, audio and USB. It has a built-in quad-band SIM800C GSM / GPRS module. FriendlyELEC NanoPi Duo2 IoT-2G
No product available!
NanoPi Duo2 is a small PCB equipped with the SoC Allwinner H3 system, RAM memory with a capacity of 256MB and a built-in WiFi / Bluetooth module. The GPIO port has been moved, among others Ethernet, USB, SPI, UART, I2C interface. FriendlyELEC NanoPi Duo2
No product available!
LOGO! Text display TD with LED backlight designed for LOGO! 8 controllers. Powered by 12/24V voltage, it allows displaying 6 lines of text, 20 characters each. Siemens 6ED1055-4MH08-0BA0
No product available!
NanoPi Duo2 is a small PCB equipped with the SoC Allwinner H3 system, RAM memory with a capacity of 512MB and built-in WiFi / Bluetooth module. The GPIO port has been moved, among others Ethernet, USB, SPI, UART, I2C interface. FriendlyELEC NanoPi Duo2
No product available!
Starter kit with LOGO! 8 230RCE, software and necessary accessories. Siemens 6ED1057-3BA03-0AA8
No product available!
Starter kit with LOGO! 8 12/24RCE, power supply, software and necessary accessories. Siemens 6ED1057-3BA01-0AA8
No product available!
Li-Po battery 3.7V / 500mAh, PCM protection, connector + JST-BEC 2,54 socket, 2 pins, cable length 150mm
No product available!
Li-Po battery 3.7V / 560mAh with 100mm cables, PCM protection
No product available!
Li-Po battery 3.7V / 600mAh, PCM + NTC protection, 1.25 Molex connector, 3 pins, cable length 35mm
No product available!
Li-Po battery 3.7V / 650mAh, PCM protection, connector + jack 2.54 JST-BEC, 2 pins, wiring length 150mm
No product available!
Metal housing for the minicomputer NanoPC T3 Plus. The set includes a set of screws allowing to assemble the housing with a mini computer and an external antenna. FriendlyELEC NanoPC-T3 Plus
No product available!
Li-Po battery 3.7V / 700mAh, PCM protection, connector, 2 pins, cable length 150mm. Akyga LP503442
No product available!
INTELLIGENT CAR INTERIOR LIGHT CONTROL - PRINTED PLATES AND PROGRAMMED SYSTEM