- Out-of-Stock
Pololu 1619 - ISD1932 Voice Recorder Carrier
ID: 195744
ISD1932 Voice Recorder Carrier
ISD1932 Voice Recorder Carrier
This breakout board from Sparkfun is a carrier for the ISD1932 multiple-message record/playback IC. It can record up to 64 seconds of voice messages with two different recording trigger modes. The chip has a flexible supply voltage of 2.4 to 5 VDC and breaks out all of the ISD1932’s pins to 0.1"-spaced headers.
 |
| ISD1932 voice recorder carrier top view. |
|---|
 |
| ISD1932 voice recorder carrier bottom view. |
|---|
Overview
This breakout board from SparkFun is a carrier for the ISD1932, a multiple-message record/playback device. This single chip can record up to 64 seconds of voice messages. Microphone inputs and speaker outputs are all handled by the ISD1932. Since this board is a carrier for the ISD1932, careful reading of the datasheet (503k pdf) is recommended.
A switch is connected to allow selection between two of the ISD1932’s operating modes: address trigger or direct trigger. You need to cycle the power after flipping the mode switch to change the mode. The board’s LED will illuminate when the device is recording.
An external resistor is necessary to select the sampling frequency, which in turn determines the recording duration. The duration can range from 21.3 s with a sampling frequency of 12 kHz to 64 s with a sampling frequency of 4 kHz.
The board breaks out all pins of the ISD1932 to 0.1" spaced headers that work with our 0.1" male headers and allow the board to be used with standard breadboards and perfboards. The boards’s headers also work with our 0.1" female headers.
Features
- Operating mode selector switch
- 2.4 to 5 VDC supply voltage
- LED indicates if the board is recording
- Record up to 64 seconds of audio
- All ISD1932 pins broken out to 0.1" headers
- Breadboard-friendly
- 1.0 x 1.3" (25.4 x 33.02 mm) size
People often buy this product together with:
 |
Electret Microphone Breakout Board |
 |
50mm Speaker: 8 Ohm, 1 W |
 |
0.1" (2.54mm) Crimp Connector Housing: 1x2-Pin 25-Pack |
195744
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Other products in the same category (16)
The module enables the replacement of a mechanical potentiometer with an electronic one, has an SPI interface and a built-in MCP4151 circuit. MOD-49
Retired
No product available!
The module enables the visual detection of the surface color, has a built-in RGB color sensor, photodiode KPS-5130. MOD-52
Retired
No product available!
The controller can control two brush motors, communicating with the master system using USB, TTL serial interface, analog signals, as well as signals from the RC apparatus. The current capacity of 15 A / channel allows you to control high-power motors. Pololu 2395
Retired
No product available!
The digital-to-analogue module (DAC) allows you to generate an analog signal, it has a built-in MCP4725 chip. MOD-53
Retired
No product available!
The ADC module allows you to measure the voltage and provide the result in digital form, it has a built-in 4-channel ADS1015 transmitter. Modally MOD-55
Retired
No product available!
The ADC module allows voltage measurement and output in digital form, it has a built-in 4-channel ADS1115 converter. MOD 56
Retired
No product available!
The DC motor driver module makes it possible to control the speed and the direction of rotation using the PWM signal, it has a built-in DRV8835 system. MOD-57
Retired
No product available!
The DC motor driver enables control of speed and direction of rotation, it has a built-in DRV8830 system. MOD 58
Retired
No product available!
ADC analog-to-digital converter module allows voltage measurement and digital output, has built-in MCP3208 chip. MOD 59
Retired
No product available!
The module enables wireless communication using Bluetooth technology in version 2.1. It has a built-in RN-42 chip with UART interface. MOD 60
Retired
No product available!
The module enables wireless communication using Bluetooth\'s Low Energy version 4.0. or Bluetooth BR / EDR, it has a built-in BM77SPPS3MC2 chip with a UART interface. MOD-62
Retired
No product available!
The module allows measuring the magnetic field in three XYZ planes, equipped with an HMC5883L sensor with an I2C interface. MOD-63
Retired
No product available!
The Explore magnetometer allows you to measure the magnetic field in three planes XYZ, equipped with a digital MAG3110 sensor. MOD 64
Retired
No product available!
Module for measuring position changes in space using a built-in sensor with 9 degrees of freedom, equipped with an LSM9DS0 system with a 3-axis accelerometer, a 3-axis gyroscope and a 3-axis magnetometer. MOD 65
Retired
No product available!
The plate allows the detection of gestures, similar objects at a distance of a few to several centimeters and the intensity of ambient light, equipped with an APDS-9960 system with an I2C interface. MOD-66
Retired
No product available!
The GPIO Expander board allows you to extend the project with an additional 16 I / O signal lines, equipped with an MCP23017 chip with an I2C interface. MOD-67
Retired
No product available!
ISD1932 Voice Recorder Carrier