- Out-of-Stock
The Parallax ColorPAL combines an RGB LED, a light sensor, and a microcontroller to make a color sensor that can also be used as an ambient light detector and a color generator. Readings are reported via a 1-wire asynchronous serial interface.
![]() |
| ColorPAL side view. |
|---|
The ColorPAL from Parallax is a miniature color and light sensor that can double as a color generator with its RGB LED. When sensing color, the ColorPAL uses its LED to illuminate a sample one color component at a time while measuring the light reflected back with a broad-spectrum light-to-voltage converter. The amount of light reflected from the sample under illumination from each red, green, and blue LED can be used to determine the sample’s color. For the ColorPAL to detect the color of a subject, the subject must be reflective and non-fluorescent. The color of objects that emit light (e.g. LEDs) cannot be detected.
Communication with the ColorPAL takes place using serial I/O, transmitting and receiving at between 2400 and 7200 baud, using a non-inverted, open-drain protocol. The ColorPAL includes a pull-up resistor to Vdd, so you do not need to apply one externally. Because of the open-drain protocol, the pin used to communicate with the ColorPAL should always be configured as an input, except when being driven low. Also, when starting up, you should wait for this pin to be pulled high by the ColorPAL before trying to send it any commands. Please see the user’s manual (297k pdf) for more information.
![]() |
Sharp GP2Y0A02YK0F Analog Distance Sensor 20-150cm |
![]() |
Sharp GP2Y0A21YK0F Analog Distance Sensor 10-80cm |
![]() |
MLX90614ESF-AAA Infrared Temperature Sensor 90° FOV |
Manufacturer
Responsible person
AI module with RISC-V Kendryte K210 chip, which can work with micro: bit, Arduino and Raspberry Pi. Equipped with a camera, microphone, speaker, IPS screen and Wi-Fi communication. Seeed Studio 101990646
No product available!
Evaluation kit with RISC-V Dual Core 64bit clocked at 400 MHz. Equipped with a camera and USB Type-C to M.2 adapter. Seeed Studio 102991335
No product available!
Starter kit for the micro:bit educational module. The kit includes an expansion module with Grove connectors, Grove modules and the necessary accessories. Seeed Studio 114991972
No product available!
A set for building a remotely controlled vehicle based on the micro:bit educational module. Seeed Studio 114991884
No product available!
The expansion module with 3 Grove connectors for the micro:bit educational module. Seeed Studio 114991850
No product available!
Base plate for Trenz Electronics modules 4 x 5 cm, eg for TE0741. The board allows connecting to the module interfaces: USB, Ethernet, JTAG, UART. TE0703-06
No product available!
The expansion module with 6 Grove connectors for the micro:bit educational module. Seeed Studio 114991848
No product available!
A set for building a smartwatch based on the micro:bit educational module. It consists of an expansion board and a strap. Seeed Studio 114991969
No product available!
Silicone case designed for the micro:bit educational module. Blue color. Seeed Studio 114991668
No product available!
Minicomputer with Allwinner H2+ ARM Cortex-A7 4-core processor, Mali 400 MP2 GPU graphics card, 512 MB RAM, 8 GB eMMC, WiFi, BT 4.0 and numerous connectors. Banana Pi BPI-P2 Zero
No product available!
3D stereo camera module, which was built of two cameras with Sony IMX219 sensor and IMU ICM20948 sensor. Designed to work with Jetson Nano and Xavier NX. Seeed Studio 114992270
No product available!
20-pin straight goldpin female connector with a pitch of 2 mm. For THT mounting. PB20S_2.00mm
No product available!
Minicomputer with Allwinner H3 quad-core processor and 512 MB RAM. It has a WiFi and BT module, two Ethernet ports, 2 USB 2.0 ports and a microUSB and a microSD slot. FriendlyELEC NanoPi R1
No product available!
Minicomputer with Allwinner H3 quad-core processor and 1 GB RAM. It has a WiFi and BT module, two Ethernet ports, 2 USB 2.0 ports and a microUSB and a microSD slot. FriendlyELEC NanoPi R1
No product available!
Metal case for NanoPi R1 minicomputer. The set includes an external WiFi antenna
No product available!
Kit with Raspberry Pi computer built into the keyboard. Equipped with a power supply, mouse, HDMI cable and 16 GB microSD card. Raspberry Pi 400 Personal Computer Kits UK
No product available!