- Out-of-Stock
Breakout Board for Electret Microphone
ID: 200848
BOB-09964 In Fritzing Library - Breakout Board for Electret Microphone
BOB-09964 In Fritzing Library - Breakout Board for Electret Microphone
Description:
Ready to add audio to your next project? This small breakout board couples a small electret microphone with a 100x opamp to amplify the sounds of voice, door knocks, etc loud enough to be picked up by a microcontrollers Analog to Digital converter. Unit comes fully assembled as shown. Works from 2.7V up to 5.5V.
Documents:
- Schematic
- Eagle Files
- Example PIC ADC Code
- Datasheet (OPA344)
- Datasheet (Mic)
- Example Audio LED control project by Adam Greig
200848
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
KAmodMIC_ELECTRET is a module with microphone KPCM6B type. Thanks to embedded amplifier with hundredfold amplification of signal, output voltage can be measurement in microcontroller with using e.g. ADC converter.
zł10.90
24h
Available quantity: 126
Available
Other products in the same category (16)
No product available!
No product available!
A development board that offers advanced programming and experimentation capabilities for smart device and industrial automation applications. It is based on the Rockchip RV1106 system, has an NPU unit and an ISP input. It offers a built-in Ethernet port, USB, GPIO, MIPI CSI and 256 MB of SPI Flash memory. Waveshare Luckfox Pico Pro M (EN)
Retired
No product available!
No product available!
No product available!
No product available!
No product available!
TEST PLATE FOR BASCOM AVR COURSE MICROPROCESSOR COIL JOINT - A KIT FOR INDEPENDENT INSTALLATION
Retired
No product available!
No product available!
Premium Jumper Wire 10-Pack F-F 12" Red
Retired
No product available!
No product available!
No product available!
Micsig DP series differential probe based on advanced SigOFIT technology. It offers a 500 MHz frequency band and the ability to measure voltage up to 3000 V. It uses the popular BNC connector and is powered by a USB Type-C connector. Micsig DP3005
Retired
No product available!
No product available!
Module with e-Paper display, 5.83" diagonal and 648x480 px resolution. Communication via SPI interface. Waveshare 5.83inch e-Paper HAT (B)
Retired
No product available!
No product available!
BOB-09964 In Fritzing Library - Breakout Board for Electret Microphone