- Out-of-Stock
AVT5388 C
ID: 208680
AVR-ISP MKII PROGRAMMER - HARDWARE SYSTEM
AVR-ISP MKII PROGRAMMER - HARDWARE SYSTEM
Producer: AVT
For writing the memory of AVR microcontrollers, programmers with the ISP serial interface are most often used. They are cheap and uncomplicated. However, these programmers lost their universality because Atmel introduced new microcontrollers, programmed using PDI and TPI interfaces. The programmer presented in the article is universal, it will be useful both for older and newer AVRs.
Recommendations: a device necessary in the workshop of every electronics dealing with microcontroller devices.
Basic parameters:
- compatible with the AVRISP programmer mk.II
- USB interface to the master system
- power from the USB port of a PC
- ISP programming connector
- PDI programming connector (Program & Debug Interface) for ATXmega microcontrollers
- TPI programming connector for ATtiny microcontrollers
- reset button (Reset)
- LEDs indicating power supply and programmer status
- possibility of powering the programmed system
- the possibility of programming systems powered by voltage less than 5V
- the ability to update the programmer firmware with USB
The system is assembled and running
attention
The AVT5388 programmer works with ATMEL STUDIO up to version 6.2 (it does not work with version 7.0 or higher). ATMEL STUDIO 6.2 can be downloaded directly from the manufacturer's website: http://www.atmel.com/tools/STUDIOARCHIVE.aspx .
A detailed description in EP3 / 13 or 
208680
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
You might also like
No product available!
Other products in the same category (16)
A module with 5 buttons and an RGB diode, designed to work with the Raspberry Pi. The buttons are connected to the minicomputer through the GPIO expander controlled by the I2C interface. Pimoroni PIM301
Retired
No product available!
Kit for controlling soil moisture of cultivated plants. It contains the HAT Mini module, soil moisture sensors and pots and seeds of herbs: basil, coriander and rosemary. Pimoroni PIM518
Retired
No product available!
Kit for controlling soil moisture of cultivated plants. It contains the HAT Mini module, soil moisture sensors and pots and seeds of chilli. Pimoroni PIM519
Retired
No product available!
A module with a spectrum sensor that operates in the visible light range (450-650 nm). It allows you to measure and characterize a light source or check how the tested surface absorbs or reflects light at specific wavelengths. Pimoroni PIM412
Retired
No product available!
Module with a UV ultraviolet light sensor VEML6075. It enables measurement of the level of UVA (350-375 nm) and UVB (315-340 nm) radiation. It communicates via the I2C bus. Pimoroni PIM460
Retired
No product available!
Module with 6-axis IMU motion sensor that combines a 3-axis accelerometer and a 3-axis magnetometer in one system. It communicates via the I2C bus. Pimoroni PIM376
Retired
No product available!
Module with two 5x7 LED matrix displays designed to work with the Raspberry Pi. It uses IS31FL3730 drivers and communicates via the I2C interface. Pimoroni PIM527
Retired
No product available!
Module with two 5x7 LED matrix displays designed to work with the Raspberry Pi. It uses IS31FL3730 drivers and communicates via the I2C interface. Pimoroni PIM526
Retired
No product available!
The system of a practical clock with an extremely simple design is equipped with a readable LED display, an alarm clock with a snooze function, and battery backup of the clock operation after a power failure
Retired
No product available!
Kit with DA7280 vibration motor driver module and LRA (Linear Resonant Actuator) motor. It allows you to add vibration feedback from the device to the project. SparkFun ROB-18247
Retired
No product available!
Kit with Jetson Mate base board designed for SoM modules NVIDIA Jetson Nano and Jetson Xavier NX. It allows you to connect 4 SoM modules and create a home GPU computing cluster or server. Seeed Studio 110991411
Retired
No product available!
Jetson Mate motherboard for NVIDIA Jetson Nano and Jetson Xavier NX. It allows you to connect 4 SoM modules and create a home GPU computing cluster or server. Seeed Studio 114992562
Retired
No product available!
ToF distance sensor (Time of flight) with a range of up to 2.5 m. The module is powered with the voltage of 3.3 V and communicates via the I2C interface. SparkFun SPX-17716
Retired
No product available!
RFID antenna designed for UHF RFID tags. It allows you to increase the effective range of tags to about 2.5 cm. SparkFun SPX-15113
Retired
No product available!
OLED display with a diagonal of 0.91" and a resolution of 128x32 pixels. It is equipped with Qwiic connectors and communicates via the I2C interface. SparkFun LCD-17153
Retired
No product available!
Starter kit with RedBoard development board and Qwiic modules: IMU, environmental sensor, GPS module, joystick, accelerometer, keyboard and proximity sensor, MP3 player, relay and OLED display. SparkFun KIT-16262
Retired
No product available!
AVR-ISP MKII PROGRAMMER - HARDWARE SYSTEM