- Out-of-Stock
AVT5396 A
ID: 208687
ECL82SE STEREOPHAL LAMP AMPLIFIER FOR BEGINNERS - PRINTED PLATE
ECL82SE STEREOPHAL LAMP AMPLIFIER FOR BEGINNERS - PRINTED PLATE
Producer: AVT
A typical amplifier constructed in a two stage amplifier configuration. The degree of voltage power was realized on the triode, while the power degree on the pentode. Due to the use of a dual-mode lamp (triode and pentode in one bulb), the structure is quite compact, and the use of popular ECL82 lamps allows to obtain an output power of approximately 1.5 ... 2 W in the SE configuration. Recommendations: a simple amplifier for people starting their adventure with tube electronics - the ECL82 tubes used are easily accessible and inexpensive.
The printed circuit board and documentation are included.
A detailed description in EP5 / 13 or 
208687
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
BOB-09168 - OSD development board on the MAX7456 chip, Sparkfun
Retired
No product available!
No product available!
No product available!
ZigBee module with an output power of 1 mW (+0 dBm) and a data transmission speed of up to 250 kb / s. Range up to 100 m. The module has 6 ADC lines (10-bit) and 8 GPIO lines. Requires an external antenna for the U.FL connector. SparkFun WRL-08666
Retired
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
RN41XV is a small form factor, low power Bluetooth radio module offering plug-in compatibility for the widely used 2 x 10 (2mm) socket typically used for 802.15.4 radio modules. WRL-11600
Retired
No product available!
The controller allows you to easily control the work of any device with the SPI interface via the USB port. All you need is a FTDI USB driver . TOL-09235
Retired
No product available!
Battery: Li-Po; 3.7V; 2000mAh; Outputs: wires with 2-pin JST-PH connector; 5.8 mm x 54 x 60 mm. PRT-08483
Retired
No product available!
No product available!
A single cell of a lithium-polymer battery, Sparkfun
Retired
No product available!
No product available!
Battery: Li-Po; 3.7V; 400mAh; Outputs: wires with 2-pin JST-PH connector; 5 x 25 x 35mm. PRT-10718
Retired
No product available!
ECL82SE STEREOPHAL LAMP AMPLIFIER FOR BEGINNERS - PRINTED PLATE