MYD-SAM9G35 Development Board

Miniature (22x13.5x6mm) WiFi module b / g / n with TCP and UDP protocols operating in standalone and access point modes. 2.0mm goldpin connector. The module is equipped with a UART interface, it is also possible to control GPIO lines (also as PWM). Powered by 3.3V. Antenna: copper wire

Ultra miniature WiFi b/g/n module, equipped with UART, SPI, PWM and GPIO interfaces. The ability to work as an access point and in standalone mode. 3.3V power supply.HF-LPT200-1

This transducer is about 45mm in diameter and has 4Ω impedance and should be run at about 5W

Read/Write analog front end for 125 kHz RFID Basestation, SOIC16, EM Microrlectronic, RoHS

Bitscope Micro is a miniature measuring instrument with a USB interface, it can act as an 8-channel logic analyzer (40MS / s, 3.3V or 5V) or a 2-channel oscilloscope (bandwidth up to 20MHz). In addition, Bitscope can generate a clock signal as well as sinusoidal, triangular, rectangular and saws

High performance WLAN USB module which enables the Raspberry Pi to connect to a Wi-Fi network

Kit for building a minisumo robot on a crawler chassis. It has a bulldozer, control board and a set of caterpillars. Robot version for self-assembly, requires additional motors and four AA batteries. Pololu 3124

Expansion module kit with Arduino compatible connectors for building a Zumo robot. The module includes a dual engine controller, buzzer and user button, as well as a 3-axis accelerometer and compass. Pololu 2508

Bi-directional converter enabling communication of any device equipped with an RS232 serial port with 802.11 b / g / n wireless WiFi network. The module can work as a TCP client / TCP or UDP server. The layout is "transparent" for communicating systems, which does not doubt facilitate communication between them.

USB A-microB USB cable with a length of 1m, white-blue cable, flat, green plugs illuminated with RGB diode

1m USB A-microB USB cable, white-blue cable, flat pink RGB LED illuminated plugs

The module is used to build prototypes and designs based on the popular ATmega8 microcontroller. It is possible to mount another microcontroller from the AVR family, if only pin outs coincide with ATmega8.   MOD-01.Z

MOD-02.Z

Module with a relay with a permissible maximum current of 10A with a 5V coil (MOD-03.Z). The module has a transistor relay control transistor and an overvoltage / self-inductive diode from the coil.

The converter enables simple connection of the project being built with the UART output to the computer via a USB interface. After connecting to a computer, a virtual COM port is created. MOD-05 / AZ