- Out-of-Stock
zł30.52
Turnigy balancer & Charger 2S-3S
ID: 213240
HK Turnigy balancer & Charger 2S-3S (7637)
Turnigy balancer & Charger 2S-3S (7637)
Turnigy balancer & Charger 2S-3S
Fits all Zippy 3S or 2S packs and charges at a rate of around 800mAh.
This is an excellent & cheap solution to charging 2 or 3S lipoly. Connect 4-5 chargers at once and charge multiple packs from the same power source!
Input: 12~15v DC
PRODUCT ID: Turnigy-3S
Download
| Customer files | ||
| This is my cost effective Gang-Charger | 184kb | |
| This is my cost effective Gang-Charger | 184kb | |
| Manual Turnigy balancer & Charger 2S-3S | 19kb | |
| Resistor wrong mounted | 172kb | |
213240
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Other products in the same category (16)
SanDisk Ultra microSDHC card with 16 GB capacity, maximum read speed up to 98 MB / s, SD adapter included. SanDisk SDSQUAR-016G-GN6MA
Retired
No product available!
High quality stable and low noise power supply for Odroid XU4 and HC1. DC 5.5x2.1 plug
Retired
No product available!
No product available!
3.5 "TFT display with touch panel, transparent housing and 16 GB SD card for Raspberry Pi 3. ArduCAM U470302
Retired
No product available!
Display with a touch screen (resistive panel) with a diagonal of 3.5 inches and a resolution of 480 x 320 pixels. Uses the SPI interface. Intended for use with the Raspberry Pi Zero / B + / 2/3 minicomputer. ArduCAM U470301
Retired
No product available!
A set of basic electronic components complete with contact plate, connecting cables and Mega2560 R3. It is ideal for beginner electronics who also know Arduino. ArduCAM KB0003
Retired
No product available!
A set of basic electronic components complete with contact plate, connecting cables and board compatible with Arduino UNO R3. It is ideal for beginner electronics who also know Arduino. Uctronics KB0002
Retired
No product available!
A set of basic electronic components complete with contact plate, connecting cables and Arduino UNO R3. It is ideal for beginner electronics who also know Arduino. ArduCAM KB0001
Retired
No product available!
Orange filament 1.75 mm 0.85 kg Easy PLA by Fiberlogy
Retired
No product available!
No product available!
No product available!
12 pin GPIO ribbon cable (200mm) for Odroid XU4 and Odroid XU4Q
Retired
No product available!
7 pin GPIO ribbon cable (20 cm) for Odroid C4
Retired
No product available!
No product available!
3-wire cable with JST-ZH plug, 30 cm, 3x1 JST, 1.5 mm pitch
Retired
No product available!
A set for building a four-wheel, remote-controlled vehicle. Equipped with a programmable Arduino Uno R3 controller and set of sensors. modARD_02
Retired
No product available!
HK Turnigy balancer & Charger 2S-3S (7637)