- Out-of-Stock

Electronic devices require power with a certain voltage value. The stabilizer is used to stabilize the output voltage at an appropriate level and filter interference. The module can be supplied with voltage up to + 16V, and the output voltage is + 3.3V.
For example, if a voltage stabilizer is connected to the + 12V power supply, then on its output we get + 3.3 V (other voltage values are also available) that we can use to power the microcontroller.
The module has a built-in protection of 500mA. If the current exceeds this value, the fuse will operate and the output will be disconnected. In this case, just disconnect the power supply to reset the protection, there is no need to replace the fuse.
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
BleBox ProxiSwitch is a miniature proximity sensor that allows you to turn devices on and off using touch or hand zoom
No product available!
Insulated fibre-optic probe with a measurement range of up to 2500 V. Operates in a bandwidth of up to 100 MHz and can be connected to an oscilloscope via a BNC connector. Battery-powered. Micsig OIP100B
No product available!
No product available!
No product available!
KAmduino UNO is a development board with functionality and dimensions typical for Arduino UNO. Thanks to the built-in ATmega328P microcontroller and the FT231X chipset, the board can be programmed via a USB interface using the Arduino environment. KAmduino UNO
No product available!
No product available!
Plastic holder that could fit all the boards with Arduino UNO size (68,6 mm x 53,4 mm). Contains 5 pieces in different colours. A000018
No product available!
A set with a camera with a resolution of 1 MPx with an OV9281 sensor, a USB 3.0 adapter and a cable. ArduCAM EK024
No product available!
No product available!
No product available!
Antenna splitter that allows one GNSS antenna to be connected to two devices, such as the NEO-D9S correction data receiver and another GNSS module. The module, based on the BP2G1+ from Mini-Circuits, evenly splits the signal from the antenna port between two outputs, providing power to the active antenna and optionally switchable power supply. SparkFun SPX-21223
No product available!
No product available!
ROSA3D filament made of high-quality PLA granules. 0.8 kg of filament with a diameter of 1.75 mm is wound on the spool. ROSA3D PLA Starter Karmin Red
No product available!
PCB for MKP - control and measurement module with USB interface. AVT5425 A
No product available!
Wrist strap for LilyGo TTGO t-wristband module. Black colour
No product available!
No product available!
The stabilizer module is used to stabilize the output voltage at an appropriate level and filter interference. The module can be supplied with voltage up to + 16V, and the output voltage is + 3.3V. MOD-06 / 3V3.Z